How can the washing machine not receive water?

The washing machine can't feed water, which may be caused by the following reasons:

The pressure of tap water itself is not enough, which makes the washing machine unable to enter water.

The joint between the water inlet and the faucet is not well sealed, and the pressure is not enough, so the washing machine can't feed water.

The solenoid valve of the water inlet pipe is broken, which makes the washing machine unable to feed water.

There is something wrong with the program to control the water inflow, which causes the washing machine not to enter the water.

The main control board of the washing machine is broken, which makes the washing machine unable to feed water.

The computer-controlled washing machine didn't press the "Start/Pause" key.

Whether the program selection is correct or not, the washing or rinsing program is usually selected, and the washing machine usually does not enter water when other programs (such as spin drying) are selected.

The dirty filter screen of the water inlet valve will also cause the washing machine to be unable to feed water at all.

The water inlet valve is burnt out, which makes the washing machine unable to feed water.

The coil of the water inlet solenoid valve is burnt out, which makes the washing machine unable to feed water.

The problem that the washing machine cannot feed water can be solved by the following methods:

First of all, it depends on whether the power supply is connected, whether it is turned on and whether the function is normal.

If the door lock indicator does not light up, please check whether the washing machine door is closed. If it is not closed, open it again and close it again, and the problem of no water will be solved.

If the washing machine door has been closed, press the door handle lock again, and the door lock light will light up, indicating that the problem lies in the micro-delay.

It is necessary to reinstall the micro delay and adjust the position of the door lock. Sometimes it is because dirt blocks the filter screen of the water inlet valve of the washing machine that water can't get in. At this time, just remove the filter screen, clean it and reinstall it.

Open the upper cover and check whether the intake valve coil is in good condition. Use a multimeter to measure whether it is normal. If the measured value is infinite, it means that there is something wrong with the intake valve coil. Replace the new coil.