Non-woven wallpaper PVC wallpaper cleaning and maintenance

Wallpaper blistering is no more common than the problem, mainly adhesive wallpaper when the uneven application of glue leads to late wallpaper surface contraction force and grass-roots separation of too much moisture,

thereby appearing in some of the built-in air bubbles.

In fact, the solution is very simple, as long as you take a general sewing needle to the surface of the wallpaper bubbles pierced, the gas will be released, and then use a syringe to extract the appropriate amount of adhesive injected into just the pinhole, and finally the wallpaper re-pressing, drying can be.

2, wallpaper moldy situation.

Wallpaper mold generally occurs in the rainy season and humid weather, mainly wall moisture is too high.

The solution for the moldy situation is not too serious wallpaper is as follows: wipe with a white towel dipped in an appropriate amount of water, or else wipe with soapy water.

The best way is to go to the wallpaper store to buy a special mold remover.

3, the wallpaper warping.

Wallpaper edges may be grass-roots treatment is not clean, adhesive bonding force is too low or wrap the corner of the wallpaper edge less than 2mm and so on, the solution: use wallpaper adhesive powder, wipe in the rolled edges of the place, the warping of the place to smoothing, with a hair dryer to blow for about 10 seconds, and then use the hand to press the real, until the adhesion, and with a hairdryer to dry can be.

4, about the wallpaper scrubbing.

With a wet or dry cloth to scrub places with dirt; can not be contaminated with some raw materials with color wallpaper, otherwise it is difficult to remove; wipe the wallpaper should be in a number of evasive corners of the wall or the door behind the hiding place to start, to avoid adverse reactions caused by damage to the wallpaper.