Solution to the method of binding fishing line and fishing rod

The schematic diagram of the tying method of fishing line and fishing rod is as follows:

One: Valve core connection mode

(1) Tie the head of the soft belt to the pole tip with a knot and fold it into a semi-circular arc. Take a section of valve core and cover it with soft tape.

(2) Thread the fishing line through the soft belt loop and tie the knot. Take back the valve core from the soft belt when taking the wire.

Two: living collar connection method

The connection mode of movable circlip is very simple and firm, which is very suitable. Specific steps:

(1) Tie a knot at the top of the soft belt first. Tie the fishing line in a circle at the top. Fold the ring pair into a double ring.

(2) Overlap the double rings together. Thread the soft belt through the ring. Tighten the steel wire so that the ring is tightly covered on the soft belt.

(3) When taking the thread, just loosen the ring and pull the soft belt out of the ring.

Three: rubber band connection method

(1) Put the rubber band on the rod. As for the position of the casing on the rod body, it can be flexibly grasped according to the length of the line (referring to the line before the tip of the rod). If you want to make the line longer, put the rubber band in the first few paragraphs of the pole; If you want to make the line shorter, put it behind the pole. Wind it several times to fix the rod so that it will not move forward.

(2) First, put a valve core or rubber cap on the fishing line, then tie a connecting ring at the end of the line and connect them with a rubber band with a connecting ring.