Steel wire braces-installation methods

1. Drilling: Remove the damaged thread with the drill nozzle.

2. Tapping: tapping the thread on the drilling hole with a special tap.

3. Installation: Use a special installation tool to gently push down the sheath and screw it into the screw hole until the distance between the tail of the threaded sleeve and the workpiece plane is not more than 1/4 ~ 1/2 turns.

4. Cut the horizontal line: When the workpiece is a through hole, pull out the installation tool, then put it across the horizontal line, and then knock it hard to break the horizontal line. Horizontal lines shall not be cut in blind holes.