How to treat automobile decomposition and structure naming?

1: As shown below, the name of the exterior part of the car.

2. The following figure shows the name of the internal structure of the car.

Concrete analysis of automobile structure;

1, total length: the largest dimension in the longitudinal direction of the car body (the distance between the outermost ends of the front and rear).

2. Overall width: the maximum dimension in the transverse direction of the car body.

3. Total height: the distance between the highest point of the vehicle and the ground.

4. Wheelbase: the distance between the center lines of two adjacent shafts.

5. Track: the distance between the center lines (along the ground) of the left and right tire treads of the same axle. Twin structure is the distance between twin center lines.

6. Front suspension: the distance between the front end of the car and the center line of the front axle.

7. Rear suspension: the distance between the rear end of the car and the center line of the rear axle.

8. Minimum ground clearance: the distance from the lowest point of the lower part of the chassis (except wheels) to the ground when fully loaded.

Extended data:

In the first half of the 20th century, after all the basic structures of automobiles were invented, automobile designers began to improve the appearance of automobiles.

The concepts of aerodynamics, fluid mechanics, ergonomics, industrial modeling design (industrial aesthetics) have been introduced one after another, which makes the car meet the different needs of people of all ages, classes and even cultural backgrounds in appearance, makes the car the best expression image of the real combination of science and art, and finally reaches the most perfect realm.