Do I have to install an automatic fire inspection cabinet?

With the rapid development of the city, there are more and more buildings, and combustible materials can be seen everywhere in the buildings, which greatly increases the possibility of fire. Although every building is equipped with fire extinguishing system at present, experience and lessons prove that the success of fire extinguishing mainly depends on whether the fire water supply equipment is in good condition. Fire pump is an important part of water fire extinguishing system, which is characterized by long-term non-use. Once it is used, it will play a role of 100%. Due to long-term idleness, the environment of the pump room is humid, which easily leads to the corrosion and death of the shaft and impeller of the fire pump, and the abnormal use of electrical components, so that when a fire occurs, the fire pump cannot operate normally and cannot extinguish the fire, endangering people's lives and property.

Fire patrol cabinets can avoid these reasons and reduce injuries.

1. The equipment has automatic inspection function, and the inspection period can be set arbitrarily within 7 days according to the customer's requirements, usually 24 hours;

2. During the inspection, the fire pumps start the inspection operation one by one with low frequency and low speed, and the running time of each pump is not less than 2 minutes, usually set at 5 minutes per cycle;

3. During automatic inspection, send a pulse action signal of less than 2S to the main low-voltage equipment in the primary circuit of the fire pump control cabinet, and check their action states one by one;

4, automatic inspection, once encountered a fire alarm signal immediately quit inspection, immediately enter the fire alarm operation state;

5, automatic detection, if found fault, sound and light alarm and memory and storage of at least 25 fault information;

6, with overvoltage, overcurrent, short circuit, lack of equal protection function;

7. There is no pressure in the pipe network during fire inspection, which effectively protects the pipe network! Patrol inspection function under pressure (customized by users)

8. SMS alarm function (user-defined)

9. The equipment is equipped with RS485 communication interface, which can complete the remote transmission of building automation operation status (user-defined).

10, water detection unit function (user-defined)

1 1, pool water level and pipeline water pressure alarm function (customized by users)

12. The equipment has the functions of fire control bus, remote monitoring and monitoring, and can be networked with the public security fire control department or the monitoring center of our company. The equipment can be monitored in real time for 24 hours, and the network center can be managed in all directions (customized by users).