How to install the computer host of the round conference table

1. First of all, you need to prepare corresponding tools, such as screwdriver, screwdriver. Usually, simple tools will be given away at random when buying a chassis. At the same time, we should also prepare various components of the host such as motherboard, graphics card, memory stick, CPU, power supply and chassis.

2. install the CPU. The installation of the host starts with the CPU. Unpack the packaging box of the motherboard and CPU, take out the motherboard, find its CPU interface position, press the lever to open it, then take out the CPU and align it. Action should be gentle and careful to avoid bending CPU pins.

3. Install the cooling fan. If the boxed CPU comes with a cooling fan, it can be installed on the motherboard together with the CPU. If you buy your own cooling fan, you need to coat the CPU with silicone grease before installing the fan.

4. Install the power supply. Put the motherboard with CPU by the side, disassemble the chassis first and then install the power supply. Here, it is necessary to tighten the screws with a screwdriver, fix the power supply in the chassis, and remove some cards on the back of the chassis to facilitate the installation of the motherboard.

5. Install the motherboard. After the power supply is installed, the motherboard can be fixed inside the chassis to determine the installation direction, and then the motherboard can be fixed with screws. Be careful not to make mistakes. You can determine by looking at the slot of the graphics card. It is generally easier to find the direction.

6. Install the memory module. Remove the memory module. If there are two memory modules, it is recommended to install them in slot 1-3. If it is a single memory module, please install it in the second slot. Press the fixed pressure rings on both sides to ensure that the memory module will not loosen.

7. Install the graphics card. Then take out the graphics card and install it in the slot. At the same time, fix the graphics card on the chassis with a screwdriver to ensure that the graphics card will not shake left and right, and the interface of the graphics card needs to face the outside of the chassis.

8. wiring. After all these are installed, you can observe the layout of the chassis and then start wiring. In principle, the simpler the better. You need to connect the graphics card, motherboard and power supply, and the motherboard may also need to connect the graphics card.

9. If there is an optical drive on the host, you need to install the upper part of the chassis and fix it with a screwdriver, and then connect the power supply and the motherboard. After all the wires are connected, you can connect the monitor and test whether it can be turned on normally.