Common problems of conveyor belt

In addition to the above deviation problems, the conveyor belt often suffers from wear, abrasion, breakage, cracks in overlapping parts, etc. These equipment problems not only accelerate the damage of conveyor belt, but also cause material leakage and waste. Usually, after the conveyor belt equipment has problems, enterprises always repair, thermally vulcanize or scrap and update, which can not solve the equipment problems well, and scrap and update even increase the equipment procurement cost. Through the study of polymer composite materials in Europe and America, it is found that polymer rubber materials can effectively solve the problems of wear, scratch, fracture and cracking of overlapping parts of conveyor belts, and can be quickly repaired online and on site.

technical requirement

It is necessary to have enough rigidity to support the material, so as to ensure that the deformation on the roller with effective spacing is as small as possible, which is very necessary to ensure the smooth movement of the material on the conveyor belt and the roller. A certain rigidity can also ensure that the material has slight bending deformation in the transverse direction, which is contrary to grooving;

The bearing capacity will decrease with the increase of tape width and material weight. For a wider conveyor belt, it is necessary to use a stronger belt core to carry materials, because the increase of load has the same effect as the increase of bandwidth. For heavier materials, you need to use a stronger belt core, because the load will be greater, and you can have different choices in the layer structure and the thickness of the intermediate adhesive layer.