How to change the extruded mop head?

We often use mops for cleaning in our daily life, but mop head will get dirty soon, so we need to replace mop head. So how can I change?

Rotating mop

0 1

First, you need to step on the cloth tray at the bottom of the mop near the edge of the middle plate.

02

Then turn the mop rod so that the direction of the screw at the bottom of the mop rod is aligned with the place where the foot steps.

03

Then lift the mop rod obliquely upward in the direction opposite to the foot.

04

Overlap the disc with the cloth disc, press and rotate it until it clicks.

Roller collodion mop

0 1

Unscrew the screw on the collodion and take out the old collodion.

02

Insert new collodion into the card slot.

03

Adjust the collodion, and the screw hole on the collodion is aligned with the screw hole on the mop rod.

04

Tighten the screws on both sides to adjust the tightness.

Folding collodion mop

0 1

Loosen the handle in the middle of the mop rod.

02

Push the collodion back slightly to make the card slot exit.

03

The new collodion is aligned with the slot completely.

04

Gently push the collodion forward, and the collodion is clamped with mop head.

First, install a connecting part on the mop rod, and then put the mop rod into the mop tray. Then, tighten the joint and mop, and don't loosen it. Finally, put the handle into the mop rod. The process won't be complicated. You can operate by yourself according to the schematic diagram below. If you don't understand anything, you can ask your mop expert for after-sales service. I believe it can be solved perfectly. The next step is the installation of cotton head. First, aim the mop tray at the cotton head tray and press it vertically downward. Then lightly step on the cotton tray with your toes to make a snapping sound, and the installation is completed. Finally, when the mop rod is perpendicular to the cotton cloth, you can step on the cotton cloth head with one foot and press the mop rod obliquely to replace it easily. Is it simple? I believe you can easily replace the rotating mop head according to the instructions.

The replacement method of the replacement head of hand-pressed cyclone mop, you hold the upper end of the mop rod with your hands, step on the white mop head cloth with your feet, step on the place as close as possible to the root, and then pull it up directly with your hands, so that the mop tray and mop head are separated, and it is good to put it on directly, without any switch, and you can separate it directly by the above method.