Paste of ordinary wallpaper

(1) Basic treatment of wall surface: The wall surface should be smooth and clean, with sufficient strength, suitable for firm bonding with wallpaper. All dirt, flying thorns, pits and sand grains must be removed to prevent protruding bubbles and degumming on the surface of the paste. Before pasting, scrape putty on the base, and then polish it with sandpaper to make the base smooth and uniform in color.

Play a vertical line near the corner, and the first wallpaper will be mounted according to this line.

(3) According to the height of the room, cut the paper up and down, leaving a margin of 2-3CM. When pasting the external corner, the external corner of the wallpaper should be no less than 2CM, and when pasting the internal corner, the external corner of the wallpaper should be no more than 10CM.

(4) Wet the paper, you can wet the back of the paper with a combination brush, or you can soak the wallpaper in water and hang it on the rope.

5] Only glue the wall, then stick one end of the wallpaper on the line, and then gently push the wallpaper to the other side with a scraper or wet towel, scratching and catching bubbles. If air bubbles remain after pasting, air can be pumped out with a syringe.

[6] Lap seam cutting (splicing), butt joint, lap joint and other methods can be used to ensure the appearance quality of wallpaper pasting.