What is the general introduction to plastering thickness?

Speaking of general plaster thickness, at this stage, what are the regulations on plaster thickness in my country’s construction industry?

What are the basic regulations?

The following is the content related to general plastering thickness compiled by Zhongda Consulting. The basic overview is as follows: Zhongda Consulting combined with the industry interpretation column of the Construction Network to inquire about the requirements for the thickness of plastering in buildings in my country. The basic situation is as follows: In order to help relevant personnel further understand the plastering thickness, Zhongda Consulting Regarding the related content of ash thickness, taking the thickness of cement mortar plastering as an example, the basic overview is as follows: The thickness of cement mortar plastering, according to consumption standards, generally exterior wall plastering is divided into three layers, the bottom layer, the middle layer, the surface layer, and the total thickness of the three layers At 15--20MM, the thickest does not exceed 25MM.

Generally, the bottom layer is about 5MM, the middle layer is about 5--12MM, and the surface layer is 2--5MM.

General extensions related to plastering thickness: First of all, you need to know the advantages and disadvantages of cement mortar and mixed mortar. 1. In dry areas, water is more likely to evaporate, so mixed mortar should be used because the water retention of lime is much better than that of cement.

2. In southern areas where the air is relatively humid, cement mortar should be used.

3. The workability of mixed mortar is better than that of cement mortar, and it is easy to mix!

Generally, it is best to use cement mortar for exterior walls!

Do not use mixed mortar!

The mix ratio is 1: or 1:3!

According to consumption standards, generally exterior wall plastering is divided into three layers. The total thickness of the bottom layer, middle layer, surface layer and three layers is 15-20MM, and the maximum thickness does not exceed 25MM.

Generally, the bottom layer is about 5MM, the middle layer is about 5-12MM, and the surface layer is 2--5MM.

For more information about bidding document writing and production and improving the bid winning rate, click on the bottom of the customer service for free consultation.