How to install the old lamp? What are the steps?

First, turn off the solar power supply;

Second, the old fluorescent lamp rotates 90 degrees, and after notches are formed at both ends, the double needle is pulled down from the notch and the other end is pulled out.

3. If there is no gap in the old rectifier, hold the lamp with your left hand and push it to the right for about 1 cm, and at the same time, move it down from the lamp holder with your left hand, and then pull out the lamp with your left hand.

Extended data:

Precautions for installation

1. If the service life of the lamp at home really ends, a new fluorescent lamp must be replaced. When the lamp is installed, if it flashes, it means that the installation is not in place and needs to be readjusted. It must wait until the lights stop flashing.

2. When replacing the new lamp, please be sure to install the upconverter. Because the up-converter plays a vital role in the lamp tube, just insert the up-converter in place and tighten it. After the installation, you can try to turn on the power switch to ensure that the lamp can be used normally.