Make a coffin tutorial video

The tutorial video for making a coffin is as follows:

Video link: web link

The tutorial for making a coffin:

(1) The worker puts a wooden bed inside the wooden box that can be adjusted in height and spreads a thick layer of wood shavings. This is actually the process of making a coffin. First the worker treats the planks with a molding machine, then carves out the shoots on one side of the planks and the grooves on the other. Then the worker applies wall glue around the edges, then treats the boards so they mortise and groove together, and secures them with curved plus money.

(2) After 90 minutes, when the glue has dried, the boards are permanently glued into a curved panel, and these curved panels will serve as the top and sides of the rectangular coffin lid. Next, the worker will use a disk to gather the ends of the curved boards, cut out the miniatures, and glue on a triangular piece of board, clamping and securing the boards tightly with a press, nailing the joints and tail-end boards as if they were large staples.

(3) Then use the machine to cut a groove in the center of the back of the coffin lid, and then glue a piece of board that becomes a bridge, use a hydraulic hammer to tighten the board with the coffin lid, the back of the coffin lid will be cut in half here at the board. Then the workers put the lid on an automatic machine for sanding, first for rough sanding and then for fine sanding, and then put the decorative wire board on the bottom of the lid, and at the same time reinforce it with screws. The groove on the inside of the wire board can be planted with the lining of the coffin, and the workers glued a small piece of wood in the middle of the groove.

(4) And sand the machine to smooth it out so that the groove is not visible when the lid is opened. Now center the lid on the bridge and cut it in half using a cutter on his side. Meanwhile, another worker begins assembling the bottom of the coffin, also called the box. The sides are glued together first and the bottom wire boards are added, then they are nailed in place with fixing nails. At this point the casket is upside down, and after fitting it with the bottom, the worker turns the coffin box over and then fits the lid and coffin box together with four leg chains.

(5) Next, the surface of the coffin is sprayed with a layer of primer, and then it is put into the oven to bake for an hour. After it comes out of the oven, workers spray it with a coat of high-gloss paint every 40 minutes, two coats a ****. After waiting for the air to dry, the coffin is then fitted with a wooden golden bundle of movable handles to put it into a height-adjustable wooden bed, followed by a layer of wood shavings on the bed.

(6) Then the worker in charge of lining the store fills the inside of the coffin with foam cotton and wraps it in flannel or satin. The fabric can be folded to create different patterns with gun nails. Often the more expensive coffins are made of very detailed fabrics and the lining points inside can be very ornate. Strips of decorative fabric are then used to hide the fastening places on the sides, and an expensive coffin with a luxurious design is created.