Planer knife blade facing up or down.

Planer blade faces up. Put the planing blade into the planing groove, with the cover blade facing up and the planing blade down, stick to the planing bed, insert the planing wedge, tap the planing wedge, screw the cover blade on the planing blade, the quick opening of the planing blade should probe out the cover blade for about 1MM, tighten it, put the planing blade into the planing groove, with the cover blade facing up and the planing blade down, stick to the planing bed, insert the planing wedge, tap the planing wedge.

Adjustment of planer blade

Left hand take the planer, the planer will be reversed, from the head of the planer to see the bottom of the planer, at this time the planer blade should be probed out of the bottom of the planer plane of about 0.15, 0.2MM, and then look at the probing part of the two sides of the uniformity of the planer blade with a hammer to tap the top of the planer edge to find the right, the edge of the planer to probe out much more, tap the front of the planer rear end, and the planer will retract into the slot, and then the planer will be able to move back to the back. The planer will shrink back to the planer, and if the planer edge is less, tap the upper part of the planer edge, and the planer edge will come out.

So repeatedly adjust the planer blade, until the planer blade probe out the size of the ideal, reverse planer body, tap the planer wedge, fasten, can be used, when using the planer found that the planer is not moving, or planer is too thick, that is, the planer blade probe out too much, adjust the planer is too thin, that is, the planer blade is too little probe out, tap the back end of the planer and then knock planer blade back end, more into the amount of knives, repeat the same action.