Video of knotting method at the end of bracelet

Knotting method at the end of bracelet

The method of tying the bracelet is as follows:

First, the right side passes through the left side, and the two ropes on the right side pass through the two knots on the left side. Then move the beads to the left rope and slowly move the crystal beads to the top of the left rope. Be careful not to move too many beads at a time to prevent them from falling off. Just move 2 or 3 beads at a time.

Tie two knots between the two sides, tighten the knot on the left side of the bracelet, tie two knots between the two knots on the left and the two knots on the right, and pull the rubber band hard after each knot to check whether it will come loose.

Then cut off the extra rope, and be careful not to cut the knot, or the bracelet will come loose. Finally, pull the knot into the hole of the first bead on the right, so that the knot can't be seen from the outside.

In addition, there is a way of ending called a diamond knot, as shown in the above picture. There are many ways to weave diamond knots. Here is a more convenient two-step method:

Step 1: Draw a circle counterclockwise with your right hand from the bottom of the black line across the red line, then press the black line and the red line and hold it down with your left index finger and thumb. Please don't make a mistake about which line you pressed. Success or failure is at stake.

Step 2: Press the black line with your right hand above the red line in the blue imaginary circle, then reverse around the red line and cross the red line circle that has just been punched counterclockwise from the bottom. The right hand properly pulls the black line and the red line, while the left index finger and thumb cooperate to hold the knotted part, thus completing a diamond knot.