How to weave Korean DIY handmade luminous rainbow rubber band bracelet?

1, get the rainbow loom ready. Read the instructions of the rainbow loom first, and then set the loom in a certain direction. Note that when placing the rainbow loom, the U-shaped plastic nail should face the machine body, even if the arrow points in the same direction as the machine body.

2. Place the first rubber band obliquely on the plastic nail. I suggest you start with the first plastic nail in the middle, put the first rubber band on this plastic nail and put the plastic nail on the left or right next to it. It doesn't matter whether you tilt left or right first, as long as you do tilt the rubber band on the plastic nail.

3. Set the second rubber band. Start with the plastic nail next to the first rubber band just now, and then put on the second rubber band obliquely.

4. Repeat the above process. Continue to cover the third and fourth rubber bands, each rubber band inclines in the opposite direction to the last rubber band, and finally you make a long and tortuous rubber band string.

5. Turn the rainbow loom in another direction. At this time, make the U-shaped plastic nail point in the opposite direction of the body, even if the arrow points in the direction of the body. This is convenient for you to hook rubber bands and knit.

6. Use crochet. Hook the second rubber band under the first rubber band at the first plastic nail in the middle with a crochet needle.

7. Put the hook part in the new position. Fold the rubber band in half (put the original rubber band on it) and then put it on the second plastic nail in the adjacent row. As for whether to put it on the plastic nail on the left or the plastic nail on the right, it depends on the direction in which you put the rubber band before.

8. Repeat the above process. Continue to hook the remaining rubber bands from the bottom of the previous rubber band, and then put them in a new position until all rubber bands are treated like this. Then you get the pattern shown above (like a series of connected circles).

9. Add a shackle. Take out a C-shaped or S-shaped shackle from the toolbox and connect it to the last rubber band.

10, remove the rubber band from the rainbow loom. Carefully remove the rubber band from the rainbow loom and pull the whole bracelet.

1 1, connecting both ends. Connect the two ends of the bracelet with a C-shaped shackle.

12, finished, see the effect, as shown in the figure below.