Connection diagram of network cable switch box

0 1

The correct name of the network cable socket we are talking about here should be the network cable module, which is generally used as the network cable jack on the indoor wall.

Twisted pair is widely used at home now. Twisted-pair cable is divided into T568A and T568B, and the access standard of information module is divided into T568A and T568B. Our network cable socket or network cable connector can only be connected in one direction, and there will be no response if it is connected incorrectly.

There is no essential difference between a and b, only the difference in color. Their respective wiring methods are:

T568A connection: green white, green, orange white, blue, blue white, orange, brown white, brown.

T568B connection: orange white, orange, green white, blue, blue white, green, brown white, brown.

Please click to enter a picture description.

02

On the genuine network cable socket, the eight wiring bayonets not only have color codes indicating the two connection modes of 568A standard and 568B standard, but also have corresponding serial numbers indicating each internal terminal and front-end pin. All the color codes on the socket are very clear and highly recognizable.

When wiring, just put each color pair of twisted pair on the bayonet of the corresponding color code.

Please click to enter a picture description.

03

Step 1:

Remove the surface of the net wire (or slot wire) in the wall with a special wire stripper or wire stripper at the end of the off-line about 10 cm long (or slightly longer for pressing the wire behind) (don't hurt the metal wire).

Please click to enter a picture description.

04

Step two:

Disassemble, and press them into the metal slots of the network cable socket one by one with wire cutters.

note:

A, some network cables are wrapped in four main colors: white, orange, green, blue and brown, instead of a mixture of white and other colors. So pay attention to put two wires in each group, and then remove the other wires. Otherwise, you will never know which of the four white lines is white orange, white blue, white green and white brown.

B, after each separation, don't press the thread first, and then use the same thread binding pliers to tie the thread one by one after all the threads are put away.

C, wire binding pliers are divided into two types, the outside is long, and the extra wire outside will be cut off after playing. Therefore, if you accidentally put the outside on the inside of the cable socket, you will cut the cable.

Please click to enter a picture description.

05

Step 3:

After cutting off redundant lines, install the information module with lines on the 86-box panel. A good cable socket has a cable protection card at the back, which can protect the cable from falling off with a gentle pull. But most of them don't have cable protection cards to protect the network cable sockets, so be careful not to pull the network cable when putting the network cable sockets into the wall and socket panel.

Please click to enter a picture description.

06

Step 4:

Insert a network cable jumper into the network port and test whether the two ends are connected to the meter; If there is no line tester, you can connect the cat and the router at the same time. If the interface light is on, the connection is successful. Then plug the wire into the wall and tighten it.

Please click to enter a picture description.