Simple paper-cutting manual course

Red colored paper, student book (large size), cardboard

Pencil, marker (dark color), eraser, ruler

Scissors, blades,

step

Draw the inside line with a pencil and ruler, measure the size of the inside line with a ruler, and draw a square on the notebook according to the measured size (choose the thinner page).

2

page 2

Write the blessing on the square with a pencil, and then outline the edge of the blessing with a pencil. Try to keep the four sides of the word Fu next to the inner edge of the square.

Revise Chinese characters repeatedly with pencils and erasers until the structure of Chinese characters is standardized and symmetrical.

Draw a blessing line with a dark watercolor pen, so that you can see the traces on the back of the page and tear off the page.

Spread the back of the colored paper upward, put a notebook under it, and then take another piece of colored paper (choose colored paper that can easily erase the pigment) or printing paper, and cover it with the back facing upward. Then cover the written page with the reverse side up.

Page 3

Adjust the position of the symbol and the colored paper below so that the symbol is in the center of the colored paper.

Use a ballpoint pen or other sharp hard objects (not too sharp, you can draw traces by force) to draw lines of blessing and let them leave traces on the paper. Be careful not to move the paper in the middle. Please always hold the paper by hand or press it with heavy objects.

When you open other papers, you will see traces of the word "Fu" printed on colored paper.

Trim the character with a pencil so that it is next to the inside line at four o'clock.

The blade broke in the middle and was cut in half with scissors. Find a piece of cardboard and spread the colored paper upside down on the cardboard.

Draw the lines of colored paper with a blade, starting with the words, and don't cut off the seams. Finally, draw the inside. If the joint is accidentally cut off, you can cut a small piece of transparent tape and stick it on the back to remedy it.

As shown in the figure, carefully remove the cut-out part, and the paper-cut of the blessing character will be done.