Manufacturing technology of mahogany furniture: how to make furniture more beautiful with ingredients?

The high value of mahogany furniture mainly depends on the type, art and material. A good mahogany furniture should not only have good material and shape, but also have scientific and rigorous production technology, and the production technology of mahogany furniture is an important factor to determine the value of mahogany furniture. As the saying goes: "Three-point material, seven-point division of labor", the composition of a mahogany furniture directly affects the service life and aesthetics of the furniture, and the wood used in different positions of the furniture is also different. According to mahogany experts, every link in the production process of mahogany furniture can not be ignored, so don't underestimate the ingredients. In fact, there is a lot of learning and stress. Let's ask mahogany experts to explain the matters needing attention in the production of mahogany furniture: wooden profiles. 1, leg material collocation. This refers to the collocation of frame materials and leg materials, and also refers to the main bone of the design frame in the process of furniture production. Only the transformation form of frame leg material modeling and the determination of material quantity can lay the premise and foundation for furniture production. 2. Reasonable collocation of small materials. The value of mahogany is scarce and precious, and the rational use of small materials and short materials is an important content of processing technology. Using artistic sculpting and structural design to improve short materials can also ensure the reasonable structure of mahogany classical furniture. 3, the combination of good and bad wood. The same piece of wood can be divided into four grades according to its quality: A, B, C and D. As shown in the above picture, the innermost part is hard, delicate and stable, which is the best choice. The closer to the epidermis, the softer the texture and the easier it is to be eaten by insects. Some sapwood parts are easily decayed by insects and cannot be used as furniture. Therefore, different wood materials should be selected according to different parts when making ingredients. The color difference and wood grain on the front of the frame, panel, door frame, door panel and main material should be basically the same.

You must use the good materials of A and B; The bottom plate, back plate and hidden parts inside the product are made of good materials in log C, which can be used to repair tiny defects without affecting the strength of the product; There are no cracks, dead joints, loose joints, rot, wormholes, deformation and other defects on the surface of carving parts.