Solution of wiring method of lamps and lanterns

The lamp wiring method requires six steps.

Tools/raw materials: power tools, fluorescent lamps, upconverters, ballasts.

1, prepare materials.

Prepare required materials, such as wires, light sticks, ballasts, upconverters, etc. , and the materials must be suitable.

2, lead to the fire zero line.

Lead the fire-fighting zero line from the main power supply, measure and distinguish the voltage of the lead line with an electric pen, and 220V is the fire-fighting line. Of course, the power must be cut off before operation.

3. Take out the ballast.

After the measurement, lead the live wire to one end of the switch and the other end to the ballast, so that the ballast is partially connected.

4. Connect the upconverter.

At present, many fluorescent tubes are not suitable for up-converters, so another wire is led from the ballast to one leg of the tube and then connected to the up-converter.

5. Connect the zero line of power supply.

Lead out the other foot and connect it to the other side of the lamp tube. Connect the following loop and connect the lamp to the zero line of the power supply.

6. Turn on the switch.

Press the switch to test whether the lamp tube works normally. The lamp goes out once, which is caused by incorrect wiring installation or poor quality of upconverter.