Traditional Culture Encyclopedia - Traditional stories - How to adjust the float in fishing?

How to adjust the float in fishing?

Bleaching flow chart

Roll the lead skin on the lead skin seat, and the lead skin must be tightly wrapped. How about fishing? Push hard and the lead skin will loosen.

Put the fish float on the float seat and put it into the water. As shown in the figure, the weight of lead makes the float sink into the water, because the buoyancy of the float is less than the weight of lead. After the float sinks into the water, move the float upward to increase the waterline until it comes out of the water. In this way, the depth of water can be measured, and the length of water depth is the distance from the fishing line under the eyes to the lead-based end. So that the water depth can be measured.

After measuring the water depth, you can adjust the drift, adjust the distance between the drift and the lead base to half of the water depth, and then put it into the water, at which time the drift sinks into the water again.

At this time, you can cut off the lead skin on the lead skin seat bit by bit with scissors, and be careful not to cut too much at a time. Every time the lead skin is cut off, the weight of the lead skin will be reduced a little. As the weight of the lead skin is gradually reduced, when the weight of the lead skin is less than the weight of the float, the float will slowly surface.

Let the float float on the water for 4 eyes. If the float rises above 4 meshes, add some lead leather on the lead leather seat to reduce the float to only 4 meshes.

Then hang the food on the hook and put it into the water, and then it will float and sink into the water. This is because the weight of lead skin and food is greater than the buoyancy after hanging food. What you have to do at this time is to lift the float up until it is 3 eyes above the water, and put it down until it is 3 eyes above the water. This is what Taiwan fishing calls "adjusting 4 fishing and 3 fishing", that is, adjusting the empty hook to 4 meshes after floating out of the water and then to 3 meshes after feeding. You can adjust 4 fishing 2, 6 fishing 3, or 4 fishing 4 by combining the above methods ... Among them, adjusting 4 fishing 2 is the most sensitive and adjusting 4 fishing 4 is the most blunt. This is what Taiwan Province fishermen call fishing spirit and fishing dullness. Generally, it's a little dull to drift in places where small fish are noisy. When there are many big fish, the drift can be reduced when there is basically no small fish stirring.