Traditional Culture Encyclopedia - Traditional stories - How to partition SSD and mechanical hard disk in computer

How to partition SSD and mechanical hard disk in computer

1, first boot pe, the figure below is the interface of pe, choose one to enter.

2, on the desktop, click on the partition software shown in the figure below to enter the partition interface.

3, after entering the partition software, click on the SSD on the left side of the partition software.

4, after selecting the SSD, click on the menu on the fast partition.

5, the number of partitions to choose a such as divided into three disks

6, and then click the location shown in the figure below to select 40964k alignment.

7, after selecting the SSD, click OK, the SSD will be divided into three partitions.

8. There is an active partition that can be used as the system disk.

9, then split the mechanical hard disk, click to select the mechanical hard disk.

10, right-click to delete all partitions, if there is a mechanical hard disk system, you do not need a new hard disk.

11, as shown in the figure below, click "OK" to confirm that all partitions will be deleted.

12, after deleting all the partitions gray, click on the Quick Partition again.

13, click to select the rebuilt MBR boot remove, according to personal needs to remove, and then click OK.

14, then right-click on the active partition, select Deactivate Status, click Yes. This will not boot the system.

15.Then click again to de-activate the partition and right-click to select Logical Partition.

16. Click "Save and Change" in the upper left corner of the software, and then click "Yes". At this point, the computer storage device hard disk completely as a data disk. The system cannot be installed. Unless redistribution is activated.