How to draw floor heating?

1, pl command, draw a rectangle along the wall.

2, o command, first offset the rectangle just drawn, input the offset value 100, (100 is the distance from the coil to the wall), and get a smaller rectangle.

3. Continue the O command, offset the obtained small rectangle, enter an offset distance of 200(200-bit coil spacing) to obtain a smaller rectangle, continue the O offset command, and continue to offset the finally obtained rectangle. Until the minimum value can no longer be offset.

4. Select all rectangles, and the X command will explode.

5. Determine the outlet direction, and two pipes will flow out, starting from the third pipe on one side and connecting with the outermost coil on the adjacent side. Use the f command to trim and connect. Connect the inner rings in turn, and manually connect the innermost ring. This is the end.

2. Software drawing:

Try intelligent floor heating design software, a highly intelligent floor heating drawing calculation software.

The unique functions of the software, such as pipe making on demand, intelligent pruning (connection) and automatic continuous labeling, can complete the labeling of all circuits in one step. On the basis of conventional software, the drawing speed can be greatly improved again. For more information, see the attachment installation package.

More about intelligent floor heating