Homemade Simple Hole Punch

Homemade Simple Hole Punch is as follows:

Hole punches are commonly used office stationery in daily life, which can be used for punching documents, information, notebooks and so on. If you need a hole punch but don't want to spend a lot of money to buy one, then making a homemade simple hole punch may be a good choice.

Materials:

1. a thick wire

2. a pair of pliers

3. a hammer

4. a piece of cardboard or plastic

Steps:

1. use the pliers will be a thick wire bent into a "U" shape, the two ends were Leave a straight section about 5 centimeters long.

2. Place the "U" shaped wire on a cardboard or plastic board, and hammer the ends of the straight rod into a flat shape, so that you can better fix the hole punch.

3. Use pliers to bend the straight rod at one end into a small loop to hang the punch on a wall or other fixture.

4. Sharpen the other end of the rod to make the "needle" of the punch.

5. When finished, hang the hole punch on the wall or other fixtures, and you can use it.

Note:

1. When using the hole punch, pay attention to safety and avoid the needle to stab your fingers.

2. The hole punch may not be as good as commercially available hole punches, and requires several repetitions to make neat holes.

3. Homemade hole punches may not be as sturdy and durable as commercially available hole punches, so you need to pay attention to maintenance to avoid damage.

All in all, it's not difficult to make a simple homemade hole punch, and you only need a few simple materials and tools to do it. If you need to use a hole punch in your home or office, consider making a simple homemade hole punch.