How to tie a kite and solve a triangle

The schematic diagram of kite triangle tying line is as follows:

Preparation materials/tools: kites, kite strings.

1. Triangular kites are usually on the lower surface, and a small piece of cloth in the shape of the Yangtze River Delta tied with kite string is sewn on the middle and upper section of the kite pole. Take out the strut and insert one end of the strut into the button of one wing of the kite, as shown in the figure below.

2. Step 2, insert the other end of the strut into another button of the kite. One or two air holes or cloth rings are usually tied on the kite line, and the air holes below are usually tied when there is a small wind.

3. As shown in the figure below, it is normal that the back pillar will have a certain radian after installation. Pass a thick short thread through the air hole and tie it with a semi-knot to form a semi-knot short circle.

Step 4: Tie the string to the front of the kite. The string is tied to the triangular tongue of the kite, only in this place. Fold the kite string back for a while and make a half knot to form a short hollow circle. Finally, tie the short loop of the kite string to the short loop on the kite and tighten it.

Flying skills of triangular kites;

1. After taking out the kite, pull out the kite string about 20 cm long, hold the bobbin with one hand and the top part of the kite with the other hand to determine the wind direction, put the kite on the ground, release the kite string for 2 meters, grab the kite string, start running against the wind, feel the tension of the wind, slowly release the kite string, and pay attention to the flying situation of the kite, and change your position according to the wind direction.

2. When the kite flies to a suitable height, loosen and pull back the kite line alternately to keep the kite flying smoothly. Finally, when collecting kites, we should pay attention to the surrounding situation to avoid unsafe accidents.