How to disassemble the door and window switch of Honda Hybrid English Poetry School?

The steps are as follows: 1. First, use a small screwdriver to pry up slowly from the edge of the decorative cover of the automobile door trim panel.

2. Then gently open the decorative cover and pry it slowly to avoid leaving traces on the surface.

3. Next, remove the screws fixing the door trim panel. Use the t-30 spline to remove the screws fixing the door trim panel, and put away the removed screws.

4. Then remove the small lamp decorative cover at the lower part of the door trim panel. Gently remove the small lamp decorative cover from the edge gap with a small screwdriver.

5. Then you will see the wiring harness plug on it, gently unplug this plug by hand, and then put away the small lamp decorative cover.

6. At this time, you will find the second screw for fixing the door trim panel, and use the t-30 spline to remove this screw.

7. The following is plastic screws's dismantling and fixing the interior trim panel of the door. Take out 10 wrench, and use 10 wrench to remove this screw.

8. At this time, all the screws of the door trim panel have been removed. Use a large screwdriver to pry up from the edge of the door trim panel, and pry up the plastic buckle fixing the door trim panel and door panel to separate them from the door panel. Carefully pry it lightly to avoid scratching the paint surface of the door panel and prying the buckle inside.

9. After prying open the buckle, you can find the wiring harness in the door trim panel. Pull off the door lock cable, and then pull off the wire harness plugs one by one. Be careful, there are many small plugs and the wiring harness is very thin. Avoid damaging the wiring harness. Be careful.

10. Finally, complete the whole door inner panel disassembly process.