Instructions for use of woodworking engraving machine

Instruction manual of woodworking engraving machine (workers who use woodworking engraving machine must read it to enhance safety awareness)

1, woodworking engraving machine installation environment must meet the working requirements of the computer.

2. The power supply must be well grounded (there must be a grounding wire), otherwise the chassis will be well connected with grounding conductors (such as water pipes, heating pipes, metal doors and self-assembled grounding wires). )

3. Power protection: The time interval of repeated startup should not be less than 30 seconds.

4. The working voltage must be between 2 10V-230V. If the voltage does not meet the requirements, a regulated power supply must be used. Right (the power is above 2000W, and the general weight is above 15 kg).

5. Spindle motor protection: If the engraving motor stops running or the motor speed is uneven, please cut off the power immediately and contact the dealer for maintenance. If the motor can't be energized when it stops running, otherwise the warp ring of the motor will burn out immediately. Please pay attention when using.

6. Use of spindle motor: The engraving motor of engraving machine is guaranteed for one year. The engraving motor we use is a variable frequency water-cooled motor with high value, so we must pay attention to the correct use of the motor. The speed of motor is inversely proportional to its life. When the motor is running, it is necessary to ensure water circulation and add an appropriate amount of preservatives. When using the motor, pay attention to the parameters provided in the manual.

7. Protection of chuck: The motor chuck and the cutter are fixed by the friction of metal, so the cutter should be oiled to prevent the disassembly from being difficult due to long-term non-disassembly or coolant corrosion.

8. Be sure to pay attention to safety when operating; Engraving machine belongs to mechanical processing equipment and should be operated according to the operating requirements of machine tools. You can't touch the engraving machine with gloves. The engraving machine belongs to professional equipment. If something goes wrong, contact the dealer in time. Only with the permission of the dealer can you ask a professional to repair it.

9. No coolant is added when cutting: when cutting with a column cutter (referring to wood, plexiglass, snow floating board, etc.). ), adding coolant will seriously affect the chip discharge, leading to tool fracture.

10, fan maintenance: clean the fan dust regularly.

1 1. Pay attention to maintenance: we must strengthen the maintenance of the engraving machine during use and extend the service life of the engraving machine as much as possible. After each use of the engraving machine, be sure to clean the engraving machine and refuel the guide rail to prevent the machine from being corroded by the environment. Because the engraving machine uses a self-lubricating and wear-resistant screw rod, it only needs to add lubricating oil once every quarter.