How to make a rabbit lantern

Take a piece of colored paper and fold it in the middle.2 Fold the two sides with the center line.3 Then continue to fold the two sides with the crease as shown in the picture, a **** is eight equal.4 Open it up and pair it along the diagonal lines.5 Open it up again and fold it parallel to the lines, leaving two horizontal compartments at the top edge. Pull out a triangle according to the crease. The triangle is diagonal oh ！！！！！ 6 flip over, the other side of the same pull out a triangle is oblique, is to do rabbit ears.7 folded paper top corner down a little, to crease hard compaction.8 flip over, the lower right side of the corner of the upward fold 9 according to the crease folded inward folded out of the picture below, folded after the outermost edge folded inward, the other side with the same do.10 the origami paper across the bottom of the bottom edge of the upward folded inserted in the inside.11 the other side is also The other side is also folded upwards and inserted inside.12 Fold the top corner of the rabbit's head, which we have folded before, inwards as shown in the picture.13 Below we fold the ears, and fold the two small corners outwards.14 Fold them outwards again, as the rabbit's ears are very large.15 Let's fold the bottom edge of the corners inwards without folding them too much.16 There are two places that need to be folded, and after folding them well, we use our hands to prop up the folded paper from the inside.17 Let's put the ears back together and tidy them up a bit. Just tidy up a bit,