100 Simple Wooden Stool Practices

Simple wooden stool practices can be found in the book Tiangong Kaiwu.

Cut two pieces of fine wood, if you use the original board as hard as possible, good flexibility of the board, the board is about length and width of 90 * 39cm, a piece for the production of the seat plate, a piece of leaning board. Cutting good, and then painted on the board need to cut the mortise and tenon line.

First, use a hand drill to drill holes at both ends of the mortise line, and then use a wire saw to cut the approximate mortise, and finally use a mortising machine to trim.

First, fix the seat plate on the top of the woodworking table with clamps. Then cut along the line with a hand saw, cutting without cutting into the drawing line. Try to cut as little as possible, you can use a woodworking chisel to slowly trim, more cuts made small.

Two 5.5 * 45cm reinforced wood slats, and then sandpaper clean. Remove wood chips and debris, and then coated with woodworking glue, and then clamped with F clamp fixed. Wait for the woodworking glue to dry and solid.

After the seat board is inserted into the backboard, the crosses will not intersect at a right angle, so you have to cut some parts. If the planks used are too thick, then here you have to use a saw to saw the bottom at an angle so that the bottom ends of the folding stool are on a level surface. After all the adjustments are made, patient sanding can be done then graffiti, painting etc.