How to install led rotating craft lanterns

Quick assembly tips:

1, first of all, the bottom of the skeleton and the corresponding hoop connection, the connection needs to take out the corresponding screws, and tighten the screws.

2, the connection is complete, the skeleton can be upright with the help of the hoop, and then take the led lantern out of the package.

3, led lantern top and bottom have metal screws, led lantern top and bottom screws placed in a horizontal state, directly into the corresponding skeleton screw slot, pay attention to distinguish between the bottom and top of the led lantern position, screws fastened, and then the top of the led lantern quick connector and the skeleton power supply on the quick connector connection, the two terminals are waterproof male and female plugs, connectivity convenient and quick.

4, at this time, the assembly has been completed, remember the top of the skeleton hoop do not connect. Because the top hoop is connected with the street light pole when? Only used.

Extended information:

LED lantern advantages:

1, energy saving

Energy efficient - in the same brightness, LED energy-saving lamps 1000 hours of only 1 degree of electricity, ordinary incandescent lamps 17 hours of consumption of 1 degrees, ordinary energy-saving lamps one hundred hours of consumption of 1 degree of electricity. 1 kilowatt-hour consumption of ordinary energy-saving lamps.

2, long life

Long life - LED super energy-saving lamps use the theoretical life of up to tens of thousands of hours or more, the ordinary incandescent lamp life of more than 1,000 hours.

3, no pollution

Light health - light does not contain ultraviolet and infrared, no radiation, no pollution. Ordinary energy-saving lamps and incandescent light contains ultraviolet and infrared.

4, green

No mercury and lead and other harmful elements, to facilitate recycling and utilization, and does not produce electromagnetic interference, ordinary lamps contain mercury and lead and other harmful elements, energy-saving lamps in the electronic ballast will produce electromagnetic interference.

5, to protect the eyesight

Light-emitting diodes using DC power supply drive, no strobe, ordinary lamps are AC drive, it is bound to produce strobe on the eyes for a long time is not good.

6, high light efficiency

Heat small, 90% of the electrical energy into visible light, ordinary incandescent lamps only 20% of the electrical energy into visible light, the other 80% of the electrical energy into heat is a great waste of limited resources.

7, safety

Smaller voltage and current required, less heat, no safety hazards, can be used in mines and other dangerous places.