How to wire a four-open bathrobe

1, ground, the yellow and green one, in the socket above the bathroom, connected to the shell of the bath bomb;

2, zero wire, most cases are blue or black, in the socket under the left side of the bathroom, connected to the five lamps screw connection;

3, fire wire, most cases are red, in the socket on the lower right, connected to the three switches of the one splice post.

Three switches, the lighting one, the other post to the center post of the lighting head; two heating switches, each of the other post to the center post of the two heating lamps. Bath bar terminal marked with N to 0, the other four have two heating lamps, a ventilation, a lighting, these four to the switch control button, in addition to a fire wire to the switch, need to pay attention to is the color of the line to be clear.

The location of the bath bomb pressure line. According to the wiring diagram above, the color of the line against the control switch L1 with the socket L bought when it has been connected. Directly in the socket connected to the fire wire, the other hole in the socket connected to zero, the other end of the switch connected to the light.

Expanded Information:

Precautions

Power wiring system to be standardized

The bathtub is not a good idea.

The power of the bath bomb can reach up to 1100W or more, therefore, the installation of the bath bomb power wiring must be waterproof line, preferably not less than 1mm multi-filament copper wire, all power wiring should be taken to the plastic culvert set in the wall, never allowed to have an open-wire set, the bath bomb power control switches must be waterproof 10A or more capacity of the qualified products, especially in the old house bathroom installation of the bath bomb more attention to standardize the bath bomb.

The thickness of the bath bar should not be too large

In the installation of the problem, consumers must pay attention to the thickness of the bath bar in the purchase can not be too large, the general in 20 centimeters or so. Because the bath bar to be installed on the roof, if you want to put the bath bar must be below the roof plus a layer of the top, which is often referred to as the PVC ceiling, so that the bath bar can be sandwiched in the middle of the two tops of the latter part, if the bath bar is too thick, the decoration will be difficult.

Should be installed in the center of the bathroom

Many families will be installed in the bathtub or shower position above, so that the surface seems to heat up quickly in winter, but there are security risks. Because the infrared radiation lamp heating fast, too close to the human body is easy to burn. The correct method should be installed in the center of the bathroom at the top of the bathtub, or slightly close to the bathtub position, so that both safety and maximize the function.