There are more and more people fishing now, so how to drift with a single hook and bait?

1. At the beginning of the bleaching adjustment step, the lead skin is cut off slowly until the bleaching tip is half an eye or level above the water. Then, hang a bait on any double hook and throw it into the fishing area. At this time, you will find that it floats and sinks, then cut the lead skin and hang a bait. Trim the lead skin repeatedly until the float can float under the net weight of the bait and stop at half water, and the water surface exposed from the tip of the float is horizontal.

However, it should be noted that the size of the bait used for drift adjustment is not the usual size. It is necessary to estimate the size of the bait at the bottom of the pond, because some of the bait will melt from the water surface to the bottom of the pond, and a normal bait will melt to about 2/3 from the water surface to the bottom of the pond. Therefore, it is necessary to take out a small ball of bait to make it difficult to atomize, and use 2/3 of the normal bait to adjust the drift. This is an important link and must be appropriate. The size of the bait cannot be changed from time to time, because the size of the bait depends on the adjustment of drift. In addition, if the buoyancy is too small or the length of the floating tip is too long, the floating tip can be exposed by trimming the lead skin 1 mesh or 1 mesh and a half; If the floating body and buoyancy are slightly larger and the floating tip is shorter (such as hollow tail), the floating tip can be adjusted to expose half an eye or horizontal water surface.

2. After state analysis and drift adjustment, throw the empty hook without bait into the fishing area. It can be seen that the float will not sink when it sinks to a certain eye, and this exposed eye number is the used eye tone. This adjustment is the most suitable adjustment combined with the net weight and hook weight of the bait. Some may have a large floating force of 3 meshes, while others may have a small floating force of 5 meshes. Just like a floating and fishing group, it may be because yesterday's bait was 3 mesh heavy and today's bait was 5 mesh light, but this is not important. It is important that this network is a central adjustment. With this central adjustment, floating is smart and slow. Then when fishing, you can adjust the state of bait at the bottom of the pool by pushing the fisheye up and down, and how to make all kinds of slow and sensitive fisheye required by everyone.

3. Adjust the drift mentioned above. When finished, throw the double hook bait. After entering the water, the float will slowly sink, and then slowly move up for a period of time until the double bait shows two eyes. The floating function of hanging fishing is mainly to control the state of bait at the bottom of the pond. It is normal for bait to keep touching the bottom in water. This floating adjustment method ensures that the net weights of the bait and the two baits will not slow down because of insufficient floating force, and the floating force will not be too large because of blind adjustment, which will lead to the situation that the bait is not allowed to be found. The purpose of applying the single hook bait semi-water floating method is to control half of the net weight of bait to be pulled up by the buoyancy of the float and the other half to be supported by the bottom of the pond. This method can ensure that the long hook can lie on the bottom of the pool smoothly and lightly, and the short hook can touch the bottom smoothly.