How to process and smoke tobacco leaves?

Question 1: How to treat tobacco leaves for smoking? Most of the tobacco leaves bought in the market are naturally air-dried. (When picking tobacco leaves, the maturity of tobacco leaves is not very strict. )

The cut tobacco in the cigarette factory goes through the following steps:

1, tobacco farmers pick tobacco leaves. Tobacco leaves can only be picked when they are ripe, not over-ripe. )

2. Baking in the tobacco farmer's small barn is called primary baking. Baking is highly technical, and there are certain quality requirements for the construction of curing barn and high requirements for the coal used. )

3. The tobacco leaves baked in the tobacco farmers' small curing barn are sent to the tobacco redrying plant for redrying. According to the requirements of cigarette factories, redrying plants should match the proportion of different parts and grades of tobacco leaves, otherwise it will affect the cost and taste of cigarettes. The mechanical equipment of the redrying plant is very large and advanced, otherwise it will affect the redrying quality. You can check it online. )

4. Enter the cigarette factory for fermentation and shredding. I don't know much about the cigarette factory. It's complicated anyway.

In a word, the tobacco leaves used in cigarette factories are all processed by complex processes. I didn't say anything about tobacco grading, material selection and formula. ) Your own small tobacco leaves are not worth dealing with. You can't handle it yourself. How much it will cost to find a factory to process it! )

Question 2: How to make dry tobacco leaves absorb soft tobacco leaves: No matter how special flavors and fragrances are, they only play an auxiliary role. The real fragrance of cigarettes comes from the tobacco leaves themselves, and the fragrance and quality of tobacco leaves are the soul of cigarettes. All the following processes are just to maximize the fragrance of tobacco leaves. Therefore, selecting good tobacco leaves is the key to self-made cut tobacco.

open

Knife shredding: First, wet the tobacco leaves, so as not to be crushed when shredding, you can cut them into thin strips. The way of wetting is also very simple. When the weather is wet, the tobacco leaves will naturally get wet the next morning.

Another method I have tried is to spread the tobacco leaves on the newspaper, take them to the bathroom, turn on the water heater and let the mist of hot water wet the tobacco leaves. This method is very fast. Under normal circumstances, a catty of tobacco leaves can be made by cutting it very finely.

Hand cigarettes can be cut in ten minutes, even faster if they are pipe cigarettes. Cutting cigarettes is like cutting vegetables, just a chopping board.

Aroma enhancement and stirring: honey and wine are mixed and put into a watering can; Sprinkle malt powder on tobacco shreds and stir; Spray honey and white wine evenly on tobacco shreds and stir. Here, the choice of liquor is according to your own taste. Wuliangye can be used for Luzhou-flavor and Maotai can be used for Maotai-flavor. In fact, Erguotou tastes good and economical.

Stir-fry shredded tobacco: after spraying the shredded tobacco with wine and honey, stir-fry soybeans and shredded tobacco at the same time (not too fast). Stop when the golden cut tobacco turns dark yellow and close to red! It may be broken at this time (you can try the microwave oven, I haven't tried it, it may not be broken if you use the microwave oven, but it is better).

Bottle fermentation: put the fried tobacco leaves into glass bottles, seal them and open them one month later. It is fragrant and delicious, better than any kind of cut tobacco on the market, and it is mainly environmentally friendly and safe.

Question 3: How to make tobacco cigarettes drain well? Hang a cigarette? Still hanging cigarettes?

Generally, there are many pipes for dry cigarettes, and the old dry cigarettes smoked by the older generation in rural areas are of this type.

Flue-cured tobacco usually comes into contact with the first flue-cured tobacco before being transported to the redrying plant. If you cut it finely, you can also smoke it with a pipe, but it is stronger. It is recommended to smoke with a hookah. There are hookahs in Yunnan. I don't know if there are any in other places. I just filter the cigarettes with water and inhale them into my lungs.

Don't use a part to make tobacco. The lower part of the cigarette has a faint smell and a faint odor, and the middle part has a strong smell and a little odor. Generally, the upper part of the cigarette has a heavy smell, so it is not necessary to smoke directly. It will be better to match according to personal preference.

Generally, tobacco is cut in a special processing place, which is very fine and uniform, and no other tools are needed.

Question 4: How to reprocess cut tobacco before use?

Question 5: How to reprocess cut tobacco to make it smoke? Don't be too dry and choking. You can spray wine or whisky on the tobacco.

Sealed storage, fermentation and aging for a period of time.

Question 6: How to smoke or shred tobacco leaves? Try dropping some essential balm on them.

I haven't smoked either, but when I see others smoking, I suggest you try.

Let me know if it works!

Question 7: If you have cut tobacco, you want to process a piece. It's normal to smoke by yourself. Generally, the cigarettes on the market are processed, and yours are not, so it is normal to react so strongly. .

Question 8: What is the best way to mix tobacco leaves? Spray honey and white wine for several hours, and then dry. It's easier to smoke.

Question 9: Is it harmful to smoke unprocessed tobacco leaves? No problem. Tobacco leaves don't need complicated processing, just air-dry!

There are many additives in tobacco leaves after complex processing, which is not good for health.