How to wire 2000w 380v metal halide lamp?

1, AC power line (brown L, blue N, yellow green line for grounding).

2, ballast (by the edge of the terminal connected to the trigger B, by the inner terminal connected to the 220V power supply line L and capacitor any line).

3, power compensation capacitor (two wires any one in parallel with the 220V power line, the other connected to the zero line N).

4, CD-7 trigger (three wires are B to the ballast, LP to the bulb fire wire, N to the zero line).

5, metal halide lamp head (two wires, one to the trigger LP, one to the zero line N).

Note:

1, metal halide bulbs in the work of charged, maintenance and replacement of metal halide bulbs should cut off the power supply to ensure the safety of electricity.

2, the power supply voltage fluctuations should not be greater than ± 5%. Voltage is too low will affect the normal start of metal halide bulbs, halogen light color and light output, voltage is too low the metal halide bulb life decline.

3, lighted metal halide bulb shut down or extinguished, shall be cooled for about 15 minutes to be the temperature of the bulb down, in order to turn on the power to start again, the hot start is easy to damage or burn the metal halide bulb.

4, metal halide bulb in the process of use, such as self-extinguishing, should check the circuit contacts and lamp base contact piece is good, whether the power supply voltage fluctuation is too large, the electrical part of the damage, such as normal, you can start again, if still out, the metal halide bulb can not be continued to use, you must switch to a new metal halide bulb.