Traditional Culture Encyclopedia - Traditional virtues - My house is heated by radiators collective heating, if the conversion to floor heating can be

My house is heated by radiators collective heating, if the conversion to floor heating can be

No. Because the collective heating and underfloor heating heating principle is different, arbitrary changes, will lead to the normal operation of the heating.

One of the heating principles of floor heating (water underfloor heating): hot water at a temperature of not more than 60 ° C as a heat medium, buried in the ground below the filler layer of the heating pipe circulating flow, heating the entire floor, through the ground to radiation and convection heat transfer to the indoor heat supply.

From the heat medium is divided into two categories of water floor heating and electric floor heating, from the pavement structure is divided into wet floor heating and dry floor heating two kinds of dry floor heating does not need to backfill the soybean stone (belong to the ultra-thin type); from the surface of the decorative material is divided into the floor type floor heating and floor tiles; from the function is divided into the ordinary floor heating and far-infrared floor heating.

Two, collective heating principle of heating: centralized heating in the system heating are power pumps, is a very small heating system are axial flow pumps to circulating water to power. In the home of the soil heating, usually by self-flow circulation. The inlet of the heater is higher than the outlet of the heater, the heated hot water is lighter and rises to the heater, the circulating water becomes cooler and heavier after heat exchange in the heater, and flows back to the heater.

Expanded information:

Collective heating attention:

1, heat users of the production of raw materials are implemented, whether the product is marketable, whether the transfer of production, stop production The possibility of the transfer of production, and the heat load after the transfer of production, suspension of production.

2, there is no first-class heat load users, and pay attention to the user's production schedule and simultaneous use of coefficients.

3. Requirements for continuous heat supply and the impact on production when heat supply is interrupted.

4, the heat load of the new heat users, should be approved through the preliminary design or the construction scale approved by the relevant competent leading authorities.

Note: the accounting of the existing heat load can be used to check the coal consumption and design energy consumption and other methods. According to the amount of coal consumption or the original design of the number of products, products, unit consumption, gas consumption patterns, etc., can reflect the real situation.

The heat load provided by the user is often a big difference, including the coal consumption, gas consumption, etc., due to the management, measurement, monitoring instrumentation and other inaccuracies, to a certain extent, can only be estimated data.

In addition, the small boiler thermal efficiency is low, often not up to the rated output, but still reported according to the rated output and other reasons, resulting in the amount of heat load and coal consumption errors. Comparison of the results of the above two methods of calculation, if the error is too large, it should be further analyzed until the final result is more in line with the actual load.

Baidu Encyclopedia - Water Underfloor Heating

Baidu Encyclopedia - Underfloor Heating

Baidu Encyclopedia - Centralized Heating