How to adjust the float for fishing beginners

Question 1: How to adjust the fishing float for beginners First of all, you hang a piece of lead on the top of the lead seat enough to let the buoy sink to the bottom of the lead, and then cast the culm to adjust the water line so that the buoy is exposed to the surface of the water for one eye, at this time, the lead seat is presented in the state of touching the bottom, and then take a look at the length of your subline and then in accordance with the formula of the buoy downward distance = subline length + 10CM, carefully trimming the lead so that the buoy is exposed to the surface of the water by Dan The number of eyes needed, in accordance with this method of high standard absolutely will not appear to find the bottom of the situation, as for what the single hook tuning, with bait tuning are evolved on the basis of this one, as long as you learn the first method, that the first I can say that the back of the tuning method basically does not change too much.

Question 2: How to adjust the float for fishing? First, find the bottom before adjusting the drift. Weight the lead pendant to throw the main line with double hooks to the fishing point, and then move the float upward, until it is flush with the surface of the water, which proves that the lead pendant has been in the end. This will help you to know the state of the bottom of the water. Such as: the depth of the water, the bottom of the water is flat, there is no debris.

Second, move the float down 20-30 centimeters or so to be greater than the drift length distance, and then cut off a little bit of lead, and then thrown to the fishing point, if you find that the float is completely submerged in the water, continue to cut the lead. Do not be in a hurry, must be cut little by little, until the float to the surface, usually I first adjusted to four, soft-tailed drift two or three can be, this is the adjustment.

Third, the next set of fishing eyes. First of all, move the float upward about 20 centimeters, and then on the bait thrown to the fishing point, the pressure of the water line, do not be anxious, if the float sinking in the water, which means that the water line is not long enough, and then move the float upward, each time 10 centimeters or 5 centimeters or so. Continue to hang the bait and throw the rod, until the float again exposed to the surface to the original adjustment, after that, you can continue to move the float up and down a small distance on the basis of this, usually one or half an eye. According to the actual situation to determine the final fishing eyes, this is the fishing eyes.

One thing to note is that you can't be in a hurry to set the mark, you have to take your time. You can also roughly adjust the float at home or elsewhere, and then adjust it a little bit according to the actual situation when you arrive at the fishing ground, because the density of water is different in each place.

In addition, the float itself absorbs water, and the difference between different quality floats is that they absorb water at different speeds. The difference between different quality floats is that they absorb water at different speeds. A water-absorbing float will cause the adjustment to change, and of course, the display of the fishing season will be inaccurate. You must know the water absorption characteristics of the float you are using, and if necessary, pull the float to half water to check it again after fishing for a period of time. This is the only way to maximize the effectiveness of the float.

Question 3: How to adjust the float for novice fishing is generally optional

Question 4: How to adjust the float for novice fishing First of all, find the bottom of the lead, the drift dew one or two eyes, and then move the drift to a distance longer than the subline ten centimeters, if you say you're adjusting the five fishing three so that you can cut off some of the lead skin in order to achieve the adjusted fishing eye five eyes. The first thing you need to do is to get a good deal on the price of the product, and then you need to get a good deal on the price of the product, and then you need to get a good deal on the price of the product.

Question 5: Fishing novice seeks to understand how to adjust the lead and drift This is to use half-water drift, half-water is not half of the water, but the fish hooks leave the bottom of the water about 30 centimeters.

1, insert the float, give the lower hook pinch a little heavier lead, can pull the float all the way into the water on the line, estimate the depth of the water in advance, such as the estimate of 1 meter, then the distance from the hook to the tip of the float is about 60 centimeters. Throw the fishing line with lead into the water to measure the water depth, the float can not be seen on the rod to push the float to the tip of the rod, many times after the test to know that the tip of the float exposed to the water surface, this time the hook to the tip of the float is the distance to the depth of the water.

2, the depth of water know, will float to the hook direction to push down half the distance, and then to the lead seat roll lead casting, if the float all of a sudden into the water is the lead is heavy, if it is the end of the drift in the water all leak out is light, according to the situation can be added or subtracted to know that the float exposed to the surface of the number of eyes is the number of eyes that you need to adjust the eye.

3, and then float to the rod tip direction to push the rod constantly cast to see the float eye, such as your half-water is 4 eyes, until the display is greater than 4 eyes to prove that the hook in the end.

4 attention to the problem, sometimes the bottom of the water is not flat or there are water plants, there may be casting each time after the display of the number of eyes constantly changing situation, to adjust in time, but also know the bottom of the terrain conditions, to facilitate the fishing.

Question 6: How to adjust the fishing buoy illustration This is the simplest way.... It is also very practical to adjust the spirit of fishing is to adjust the eye high, fishing eye low (adjust 4 fishing 2, adjust 3 fishing 1, buoy without bait half-water floating 4 eyes plus bait for 2 eyes, find the bottom, slowly adjust to the remaining two eyes, this time the bait touches the bottom), adjust the spirit of fishing is to adjust the eye low fishing eye high (adjust 2 fishing 4, adjust level fishing 2, in the end 2 eyes, continue to adjust the depth of 4 eyes, this time the bait lying on the bottom, the fishing line is bent), adjusting the ton fishing is to adjust the eye high Fishing higher (3 fishing 5 4 fishing 6, the same, the bait is lying on the bottom, the line is bent just fishing higher, the higher the fishing higher the ton)...

Question 7: I am a beginner in fishing, how to adjust the drift, what are the steps

① Prepare the hook and line

② Tie something on the line that will float

③ Insert a worm on the hook

④ Then throw it out

⑤ Wait for the fish to come and eat it

⑤ The fish will come to eat it <

⑥When the fish eat those floats will, a little move move a little

⑦When the fish bite the hook this time you feel, there is gravity to pull down, and then you use a little force to pull it up.

Question 8: Hand rod fishing novice drifting skills how to adjust the pendant drift and find the mouth of the steps

First, leisure fishing carp drift and try fishing steps:

(a), fishing bottom of the basic drift steps:

1, rough bottom:

Leader seat hanging heavy lead, the weight of the lead is greater than the buoyancy of the float, the float is all out of the water, and gradually pull up the float to reveal the first eye, the most important thing is that it can not be seen, but it is a good idea. Floating to reveal one eye, the top space bean position next to the second space bean, to complete the positioning, remember the top space bean to the end of this fishing do not move. (At this time hang or not hang the subline can be.)

2, adjust the aim:

Hang up the subline, float down about 30 centimeters (remember to float down the distance & gt; long subline length + 10 centimeters), at this time, the float should be all out of the water, and gradually cut the lead skin to reveal the required number of eyes (adjustable eye).

3, carp fishing tuning and fishing set the basic principles:

7 eyes soft tail drift bait: adjust 4-5 eyes fishing about 2 eyes

7 eyes soft tail drift bait: adjust 2.5-4 eyes fishing about 2 eyes

Hard fine-tailed bait: 7-9 eyes, fishing 2-3 eyes

Hard fine-tailed bait: adjust 4-7 eyes, fishing 2-3 eyes

The fishing eye is high, fishing blunt; fishing eye is low, fishing spirit.

According to the weather, season, bait specific gravity, the size of the bait group, the mouth of the fish, and other factors, and then to be fine-tuned adjustments:

4, accurate bottom:

Move the float, adjust the float seat position and has been positioned on the space bean position of the distance and the length of the subline roughly equal, the lower hook rubbing bait to hang large bait group to find the bottom (and at the same time is also a nesting), so that the floating surface exposed to the water for 2 eyes, continue to pull up the floating 2 centimeters, and then pull up the float. Continue to pull the float up 2 centimeters, if the float shows more than 3 eyes, it represents the bottom, the float down to pull back 2 centimeters, this action is known as the reverse of the bottom, and then hang a normal casting size bait group casting into the water, fine-tune the float to the fishing eye in 2 eyes or so to test fishing.

5, test fishing adjustment process

(1) mouth without fish: fishing too Ling, pull up the float 2CM (can be continuously pulled up to 5 times), the above lip continuous fish more than 2 times to find the mouth. (Too spirit can be interpreted as finding the bottom is not correct, still off the bottom)

(2) fish for the mouth or lower jaw, this is fishing too blunt, every time you pull down the float 1cm, to the upper lip of the fish more than two times to find the right mouth. (Too blunt can be interpreted as finding the bottom is not correct, has been over the bottom)

(3) fishing bottom no mouth: each time you pull down the float 15 centimeters, to find the fish where the water layer, which has been fishing off the bottom - fishing float - fishing a standard depth of the category, you need to cut the lead to adjust the drift to hang a pair of baits, floating in place after the exposure of about 2 eyes, as described in the other.

(B) running lead fishing:

1, the scope of application: the flow of water or small fish when the hook is used, fishing method is similar to traditional fishing.

2, running lead drift steps

(1) No hook state, heavy lead to the bottom to find the bottom.

(2) Pull down the float by 20cm and cut the lead to level the water.

(3) Open the upper space bean of the lead ball about 5 centimeters.

(4) Hang the subline, pull up the float to reveal the drift 2-6 eyes can be fishing, the rapid flow of the drift to reveal more

3, running lead fishing method Note

(1) running water environment, try to use a large float, positioning ability, such as Dagger A118 of the No. 3 drift.

(2) The subline should be as short as possible, within 10 centimeters, because running lead fishing is extremely blunt, and a short subline can amplify the signal.

(3) Catch both the upward and downward movements, and you will be able to catch the fish.

(4) The bait can be sticky.

Second, recreational fishing to find the mouth of the detailed steps:

1, the drift phase is only a slow rise but no downton mouth, or rise only slowly after the Yin Yin drift phase, can be adjusted by pulling the drift down. The first thing you need to do is to pull down on the float and adjust it until there is a slow rise and then a dry, slight lurch and a hit.

2, the drift phase only slowly rise but no downton mouth, pull down the drift to adjust the fishing eyes is invalid, mostly with the bait state, the size of the bait can be adjusted in time to bait state and baiting techniques and then go to the mouth to ask, explore.

3, the drift phase only slowly rise but no downton mouth pull down the drift to adjust the fishing eyes and adjust the bait and bait techniques are also invalid, then you can reduce the lead and then go to re-find the mouth, until there is a dry mouth of the micro-ton, and fish.

4, the drift can not fall to the set fishing eyes, or high top for a long time does not fall, in the exclusion of casting inaccurate, lost bait and other factors are mostly due to the fish interface, you can also pull down the drift to adjust or reduce the lead to find the mouth.

5, the nest of fish star four, but adjust the fishing eyes are still no mouth, should check the bait hook rate and atomization rate. At the same time, you should check whether the tuning is too blunt, drift and tuning, bait is not recognized by the mouth of the fish in the mud layer of the false bottom.

6, fishing eye spirit blunt adjustment are no mouth, adjust the bait state and baiting techniques are invalid, can reduce the lead to increase the adjustment to improve the ability of the drift bait, and increase the fishing eye adjustment to find the scope of the question, so that the bait in the virtual bottom layer of the layers of the layers of the more choice ....... >>

Question 9: How to adjust the drift and find the bottom of the fishing You see this picture drift tutorial and find the bottom of the method to know.