How to use wool to play cotton shoes and cotton slippers weaving method What are the

First, weaving slippers face:

(with two colors of wool, red, yellow)?

① red wool starting 6 stitches, knitting the first line; back to knit the second line, the first needle is not knitted, the last needle before adding a needle, and then knit the last needle; and then back to knit the third line, the first needle is not knitted, at this time, it has been 7 stitches.

② At the beginning of the fourth row, use the yellow wool, pull the red line a little tighter, pull it to the back, and start knitting with the yellow line over the red line. The first needle directly removed, do not knit; the second needle began to knit yellow thread, knit to the penultimate needle, add a needle, and then knit the last needle; and then turn back to knit the fifth row, the first needle is not knitted, at this time a total of **** 8 stitches.?

③ At the beginning of the sixth row, first pull the yellow thread to the back, and use the red thread to press down (cross over) to start knitting the sixth row, in the same way as above.

④ so repeated, knit to about 54 stitches or so (you can use the sole of the shoe to measure the edge of the added stitches, a little tighter to measure, measure half of the sole - the center line is separated, and only measure half of the edge.) , start shuttling the front toe portion of the shoe. Start with the yellow thread as an example. The first line of the yellow line knitted over, back to the original method of knitting, the last 4 stitches remaining do not knit, replaced by the red line knitted over, at this time the red line knitted over the past, do not add needles (so that the front is flat, will not be pointed.)

The last 4 needles are not knitted, the red line knitted over, do not add the needle (so the front is flat, will not be pointed).

⑤ Weaving the middle part, the red line began to shuttle back. That is: when knitting the red thread, first knit the last dozen or so stitches, then knit the remaining 5 stitches (red) together, after knitting these 5 stitches, immediately switch to the yellow thread to knit over, turn back and then knit the remaining 5 stitches (yellow), and so on and so forth until all 40 stitches of the front shuttle have been knitted.

6 All finished knitting in the middle of the remaining 40 stitches, knitting the first line of attention to start closing the needle, that is: the original place to add the needle, now become the last two needles into a needle, pay attention to do not pull too tight, the edge of the shoe is too tight easy to make the face of the shoe smaller, left and right asymmetry. Back knitting method no change. This has been received only 6 stitches left on all the needle broken line. Now the face of the shoe is like a bat with wings.

Two, weaving slippers lining:

You can use the old line or pure wool to weave the lining. Generally use 3 strands of thicker wool to knit, knitting method is the same as the face, only the number of needles is different. The first 2 stitches, to the face of the timely comparison of the width, about 20 stitches on the front of the shuttle, each time the remaining 3 stitches, the last remaining 5 stitches on the back of the shuttle, do not have to repeat these 5 stitches. If you don't like the thick lining, you can adjust it appropriately.

Three, on the shoes:?

①First on the face. Face the front of the face to face the bottom of the sole, find the middle of the top of the sole, align the front of the face to the front of the sole (do not be crooked), use two threads to fix the front part, to avoid pulling straight on the other place when pulling the crooked, and then use a strong thread from the back along the edge of the upper.

② Then on the lining, the same method as above.

③ Then, cut a pair of insoles from an old sweater (you can also knit insoles with thread) and sew them on the soles.

④ Finally, turn the lining over, and then turn the face over, a pair of woolen slippers will be finished.