Traditional Culture Encyclopedia - Traditional virtues - How to fish traditional running water fishing
How to fish traditional running water fishing
Fishing in running water is a little more complicated and difficult than stillwater fishing, do you know what methods are available for this type of fishing? Let me tell you how to fish traditional running water fishing.
Running Water Fishing Method 1: Walking Label Fishing Method
When the above conditions are the same, but the water flow rate is larger, the bottom of the fishing station can not stand when the label I will use a reduced lead fishing walking label method.
Specific method: reduce the lead skin so that the buoyancy of the standard is greater than the gravity of the hook bait, line and pendant, so that the hook bait off the bottom, the surface of the water only left 2 to 3 grains of the standard, so that the line group move with the current. When operating, you should throw the hook bait to the upstream of the fishing point, and use the water current to make the hook bait drift over the fishing point, and so on cycle operation. In this process, if the fish eat the hook from the level or below the hook bait, the mark is usually black mark, to eat the hook from above is usually send mark. When you find that the fish are swimming in a higher layer, you should adjust the hook bait height in time to cope with the change.
Running water fishing method 2: Lead fishing method
First of all, it's a good idea to adjust the marking in the place where the current is slower. My tuning method is to adjust the flat water with an empty hook, and then fish 2 to 3 grains after baiting. If you go, you can pull up the loose mark and increase the distance between each star mark, fishing 4 to 5 grains. If this is still go mark, you have to add lead, until not go mark. Bottom fishing in the wild waters, there is an uneven bottom, and there are often withered leaves, hook bait will sometimes be covered, the fish can not see the bait; and if the tuning is too flexible, and will go mark, this? The fall on the hook? There is a place for this. The practice is to move the lead skin down gradually, so that the hook bait off the bottom, easy to be found by the fish. Move the distance to the fish to eat the hook is good, this not only solves the problem of the fish can not see the bait, but also does not affect the sensitivity of the fishing group. This will solve the problem of the fish not being able to see the bait and will not affect the sensitivity of the fishing group. Plus, the earthworm itself is alive, and then pushed with the current, more dynamic effect, very tempting.
In the process of fishing, we should pay attention to two specific issues:
1, when casting the hook must ensure that the landing point in the bait package downstream and close to the bait package. This is because the current will wash the scent downstream, unlike in still water where the bait scent is diffused in all directions.
2, earthworms are eaten by small fish after the hook is exposed to the tip of the hook, lifting the rod without paying attention to the bait bag is very easy to get hung up on the bait bag, which will bring trouble to fishing. We need to be diligent in checking whether the hook tip is exposed or not, and also pay attention to the downstream direction when lifting the rod.
Fishing Method 3: Trolling Without Marks
When the current is strong or there is a strong wind, the first two methods can not be used, and then I use the trolling method without marks. This method requires the rod tip to be soft, with small hooks and fine line, drop a little heavier, must use worm bait fishing.
Specific fishing method: cast the hook bait to the fishing point downstream, and then slowly drag the hook bait upstream, so that it passes the fishing point. During the towing process, the wind line should always be taut, with a slight bend in the tip of the rod, and the towing speed should not be fast but consistent, if no fish eat the hook, then repeat the operation from the beginning.
In the process of dragging, if there are fish eating hooks, there are generally two kinds of fish news: one is dragging the hook, because the rod tip is soft, the fish will eat the hook after the rod tip will appear to point, continuous and increase the amplitude of the phenomenon of bending, the emergence of this fish news can be silently counted two seconds to get up; the second is to send the hook, drag the process of the wind line suddenly flaccid, which is due to the mouth of the fish good, directly to the mouth will be caught in the mouth of the bait and head up due to the rod, then you should get up right away.
The trolling method is quite tiring, and it is a little easier to operate with both hands, and you need to practice many times to be able to use it skillfully.
Fishing tips for using floats in high winds:
A. Slanting and lying floats
In the case of high winds and waves, the floating float may be drastically and violently shaking and floating up and down with the waves, and it is very difficult to see the float. Therefore, some anglers simply change the drift to a slanting or lying drift.
Second, the vertical drift
Fishing in the wind and waves, generally use a larger float, a heavier pendant, a shorter brain line, a long pole and a short line, the wind line is shorter. In the case of wind and waves are relatively small, you can use a standing float, according to the normal no wind drifting method of drift tuning, to keep the float drift tail exposed to the surface of the water for a certain number of eyes, neither too short, so as to avoid the waves come to the end of the drift is not invisible; and do not be too long in order to minimize the impact of the wind. In the case of wind and waves, the length of the drift tail exposed to the water tends to be longer than when there is no wind and waves, in the end, how much longer is appropriate, depending on the size of the wind and waves and the experience and habits of each person.
In the case of wind and waves, it is more difficult to see the drift. Experienced anglers are more likely to take the point where the drift tail meets the water surface as the benchmark, and find out the pattern according to the drift's sinking and floating, and the swaying situation, and figure out which state is due to the influence of wind and waves, and then once you find the anomaly, for example, the fish bite similar to the usual fish bite? Once you find an abnormality, such as a bite similar to the usual fish bite? The first time you see a fish bite, you will see a "lunge," or a "lurch. top? or? Sinking? This is most likely that the fish are biting, and you can usually catch the fish by lifting the rod. If you are watching TV or rocking a boat, and you don't pay attention to a certain benchmark for reference, and you don't notice any unusual changes in the regular sinking and floating of the float, you won't be able to easily catch the fish biting signal, and it will be difficult to catch the fish.
The adjustment method of slanting and lying drift
Generally, we use a larger float, a heavier movable pendant, a short brain line or cancel the brain line and change to a hook with a pendant, and the gravity of the pendant is a little bit bigger than the buoyancy of the float when it is deep in the water. After placing the hook, the hook and the pendant are sunk to the bottom of the water, and the float does not go into the water, and then we run the space bean on the two sides of the float seat upwards to increase the water line, and the end of the float is exposed to the water surface until it inclines at an angle to the water surface, which becomes an oblique angle to the water. The water surface is tilted at an angle, becoming a slanting drift. If you continue to stroke the space beans upwards to increase the water line, the float will lie on the water and become a horizontal drift. When you use the drift, the float will not only be affected by the wind and waves, constantly shaking, sinking and floating, but if the fish bite, the drift may appear like the pointer on the dashboard dancing up and down, suddenly cocked, suddenly down or sinking, different from the wind and waves produced by the shaking, then you may hit the fish when you lift the rod. The situation is almost the same with the oblique drift, the float lying on the water surface, with the wind and waves swing swing floating, as long as the float is found to be suddenly up and down, up, down or sinking than the float tail, generally is the fish bite signal, then you can start.
The reflection of the fish bite signals by the oblique drift and the horizontal drift
Generally, the drift is more sluggish than the vertical drift, and the horizontal drift is even more so, but the horizontal drift is better to observe and judge. These two methods are more obvious to the fish that are swallowing the hook, biting heavily and dragging the fish away. For sucking type, light biting fish, the signal is often not obvious. That is to say, sometimes the fish bite, the float can reflect, and sometimes do not reflect.
People who have read How to Fish Traditional Running Water Fishing will see:
1. How to Fish Traditional Fishing in Running Water
2. Traditional Fishing Methods
3. River Fishing Tips
4. Beginning Traditional Fishing Tips
5. How to Fish in Scattered Ponds
- Previous article:How to say traditional food in China in English? Spell it in Chinese.
- Next article:Common sense of ancient culture in senior high school
- Related articles
- How do you see Jay's status in pop music?
- What props are there in Beijing Opera?
- What are the characteristics of the hound that rushes to the mountains diligently
- What is the construction enterprise culture?
- What are the irrigation technologies for farmland in Xinjiang
- The most traditional upside-down golden bell variety
- How to Cultivate Crucian Carp How to Cultivate Crucian Carp
- What are some of the easier cuisines to make at home?
- What's the difference between a seven-day independent big bed room and an economy room?
- The ways to accept orders include traditional ordering and electronic ordering, and the specific processes include