The right way to row mop mop

The correct way to row mop mop

The correct way to row mop mop, mopping is often a thing that every family has to do, but there are often a lot of people complaining that the floor of the home is always mopping is not clean, if you do not mop up too much dirt on the human body is harmful. The following share row mop mop the right way.

row mop mop the right way 1

A row mop mop the correct way to use

The use of row mop mop mop, the first will be all the parts installed, the connecting rod should be connected in place, and then mop loaded into the chassis. Installation is also relatively simple, there is a kind of Velcro mop cloth, just need to put the mop cloth on the ground, and then straighten the mop rod, align the mop cloth, paste on it.

Prepare a basin of water, soak the mop cloth all wet, after that use the mop bucket to squeeze dry, you can come to mop the floor. Because it is a flat type, it can be pushed along the corners of the wall to be able to clean 90-degree corners in place. Using the mop again, take the method of mopping from the inside out, the human body can stand upright without bending over.

While mopping the floor, backing up, the hand should be hard to rotate the mop lever. Until the ground mopping clean until, finally we will mop cleaning, put into the sun to dry, ready for the next use.

Second, row mop mop velcro does not stick how to do

1, mop cloth used for a long time, if you choose to use this Velcro, because the paste a lot of sundries, over time there will be a phenomenon of non-stick. You can use a sharp object to remove the debris pasted on the hard plastic hook side of the Velcro.

2, and then the mop cloth cleaned, dry, through the clipboard or iron, put on the top of a little heat. But if some of the surface of the sticky surface hair has fallen off, or wear off very strong. In this case, you can only replace a new Velcro or directly replace the new mop cloth.

3, there is a kind of snap type mop, do not need to use Velcro, there is no late will not stick phenomenon. And the snap type paste will be more solid, not easy to loose.

Summary: The above specific introduction is the row mop mop the correct way to use, relatively speaking, this mop cleaning ability is still relatively strong, can be cleaned up indoor dead ends in place.

row mop mop the right way 2

1, mop the floor which mop is good --- sponge mop

First of all, the sponge has a special quality, is all the materials in the absorption and contraction function in the excellent one of the products. The sponge mop is designed with a high-fiber brush head that can hold confetti and dust firmly on the brush head, so it's very easy to use. The ordinary mop brush head is made of cloth, can not automatically absorb water, through the wringing or squeezing way to eliminate water, it is more troublesome to use.

2, mop the floor which mop is good --- cloth mop

Secondly, the cloth mop is the most common, but also the most traditional kind of mop, in the end of the stick tied to the cloth, so that it can be used. But this mop cleaning ability is not strong, cleaning and dehydration is also more laborious, in addition, the cloth is easy to breed bacteria, is not conducive to the health of the family, therefore, has been gradually eliminated by the market.

3, mop the floor which mop is good --- row mop mop

Finally, we would like to introduce you to the row mop mop, which is the most widely used on the market at present a kind of mop, which not only can be wet and dry, but also can effectively remove the water on the ground, to protect the health of the family. In addition, it also has the effect of protecting the floor and preventing static electricity, therefore, it is favored and liked by everyone. But when choosing a row mop mop, be sure to choose a product made of microfiber, so that in the absorption of water `simultaneously, it can also adsorb dust, hair, pet hair and other items on the ground.

floor how to drag and fast and clean

1, to sweep the ground first, and then in accordance with the order from the bedroom, living room, bathroom, kitchen, one by one, so that it will not dirty the floor.

2, first use the broom to remove the impurities of the ground clean, and then wet the mop with water, in the excess water extrusion, no water is appropriate, in the most inside the room from the beginning of the mop, so as not to mop up and then be stepped on after the dirty.

3, if the home installed wooden floor, then, in order to use a special mop, it is best to buy a mop can be dismantled products, so that it is easy to clean and replace. In the cleaning, it is best to buy a bottle of essential oils, essential oils evenly dispersed on the floor, in the use of a special mop, the ground watermarks and stains can be cleaned up.

4, if the home installed tiles, it is necessary to clean once, and then mop with a mop can be.

5, if there is dust on the ground, it is best to use a flat mop to clean the floor.

row mop mop the right way 3

a mopping principle

1, what is mopping, mopping is a way to clean the floor, mainly the use of cloth or sponge and other materials made of mop, in the dissolving effect of the water, through the entrainment, adherence, adsorption, dewatering and other means of handling, the floor on the dust, impurities clean up Clean a cleaning method.

2, mopping principle:

A, entrapment method, the use of cloth between the superposition and entanglement of the formation of parcels, entrainment away from the larger and not dissolved in water dust and impurities. Spongy mop in this regard, the effect is poorer, only the use of sponge grooves with some of the lighter impurities, such as hair, threads, etc.;

B, the method of adhesion, the use of cloth or sponge wetting with the ability to adhere to the lightweight and insoluble in water dust and impurities away;

C, the method of adsorption of the dissolution of the use of mops to carry the amount of water, through the water of the fine dust, impurities dissolved, the formation of a mixed solution, that is, sewage, the use of cloth, sponge absorbency, the sewage adsorption, carry away, and then the mop dehydration, dehydration, repeat adsorption, carry.

Second, the evaluation criteria of a good mop

Through the above understanding of the working principle of mopping, a good mop should have the following three characteristics

1, a strong entrapment and adherence to the ability to entrap and adherence to the more, the larger as well as not dissolved in the water of the dust and impurities

2, a strong Water-absorbing ability, can bring enough water to dissolve dust and impurities, and at the same time can adsorb a large amount of sewage, to realize the safe transportation of sewage.

3, has a strong dehydration ability, can quickly and thoroughly unload sewage and stains not dissolved in water, clean the mop itself, for the next adherence, adsorption of sewage, dirt and prepare conditions.

Third, the main steps of mopping

1, sweep

First of all, use the broom to the floor of the dust and impurities thoroughly swept once, sweeping is the realization of mopping work fast and good prerequisites, even if the floor can not be seen by the naked eye of the dust and impurities, but also to be serious! Sweeping. The general cleaning can be once.

2, dissolve

After cleaning, the mop will be wet, to maintain a large water content, the water content should be enough to dissolve the floor residual soluble dust, impurities. General use of wet mop drag once or twice, enough water, stains basically dissolved on it

3, adsorption, handling, unloading

floor wet stains dissolved, the mop will be cleaned and dehydrated as much as possible, with a dry mop to mop up the floor, repeated 3 times or so, the residual sewage adsorption of the surface of the floor, clean. The mop is permeable without sewage until.

4, dry

After the basic adsorption of water on the floor clean, keep good ventilation, in the floor before the surface is completely dry, try not to walk.

Fourth, the operation of the main points

1, sweeping to be thorough

Many people think that the broom is to sweep the floor with a large 'sundries, the floor of the naked eye can not see the basic impurities, there is no need to sweep the broom first, a waste of time. This point of view is wrong, first of all, sweeping once, than mopping once to save a lot of time; Secondly, if the impurities can not be removed by sweeping, use the mop to dissolve - handling - dehydration to remove later, the time spent should be more than 3 times, in other words, first thoroughly sweeping once will give you a mopping later to save more than 3 times the time.

2, dissolve to be sufficient

After the floor is clean, really into the mopping stage, initially the mop must have enough water to play the role of dissolving stains, water is too little, dissolve insufficiently, can only rely on the entrainment and dabbing with the take away the stains, it will increase the time of mopping; water is too large, increase the workload of the adsorption, but also increase unnecessary time. Increase unnecessary time

3, adsorption to be completely

The ground sewage must be adsorbed clean, otherwise the floor after drying, is still dusty, equivalent to no mopping.

4, handling in time

After the dissolution of the sewage must be adsorbed in time to carry away, this time the work must not be aborted, if this time to stop, the floor of the moisture after drying, only to revert back to the previous step, to take the wet mop of the water content of the stains to dissolve again, and then dry mop the sewage to carry away can be.

5, regular cleaning with detergent

There are a lot of dust and impurities are colored, or contaminated floors, there are also stains with poor solubility, less dissolved in water, if the long-term mopping of the floor with water only, it is difficult to clean up. Over time, the stains tend to accumulate on the floor, which will affect the luster and color of the floor. In general, every week or two weeks, you should mop the floor with a mixed solution of washing powder + detergent (add the right amount of 84 disinfectant if necessary).

Using warm water to configure a higher concentration of laundry detergent and detergent mixed solution, mopping method and water mopping is the same, sweeping - dissolve - adsorption - handling, the difference is that the mixed solution to carry away, but also with a large amount of water to repeat the mopping once again, again to complete the dissolution - adsorption - handling of the steps, to avoid the mixed solution to corrode the floor or cause the floor slippery, affecting the safety of walking.

6, on the "watery odor"

After the floor mopping, in the process of drying, sometimes exudes a kind of unpleasant fishy smell, commonly known as "watery odor". ". In fact, this flavor is not from the water, not from the floor itself, but the microorganisms on the mop caused. There are two ways to remove the "watery smell", one is to regularly use the "84 disinfectant" soak and thoroughly clean the mop (after soaking must be cleaned with water in a timely manner, 84 disinfectant oxidizing solution is very strong).

General soak for fifteen minutes; the second is sun exposure, so that the mop is often kept dry (sponge mop can not be exposed to sunlight, it is very easy to aging in the sun, hardening, loss of water absorption)