How to wire the bathrobe light installation method

To the bath bar light wiring is not directly into the line, according to the previous text will be wired into the appropriate interface, and then tighten the screws, so that the bath bar light can be used normally, the specific steps are as follows.

Tools / raw materials: a bath bar light, six wires

1, first pick up the yellow lighting line, the lighting line into the upper right corner of the interface inside.

2, with a tool to tighten the screws on the side of the interface, and then pick up another gas line.

3, this wire into the upper left corner of the interface inside, again with a tool to tighten the screws on the side of the interface.

4, according to the previous text to distinguish between heating 1 and heating 2 interface, first access to the heating 1 interface at the wire.

5. Tighten the screws on the side with a tool, and then plug in the wire of heating 2.

6, and then take the red wire, the wire to the switch L interface.

7, access and then use a screwdriver to tighten the screws inside, so a bath light is connected.