Weaving method of Chinese knot goldfish

1, with a green line as the axis, tied at the top of seven lines, and the connecting line as the midpoint.

2. Make a circle around the shaft and hang a green line at the intersection.

3. Divide all rows into four parts, as shown in Figure 4. There are eight lines in the upper two parts representing the abdomen of the small fish, and ten lines in the lower two parts representing the back of the small fish.

4. Nail two lines as the axis, and conduct winding and oblique winding according to the above eight lines.

5. Tie eight ropes together, first tie the fish's back below.

6. Take the line on the nail as the axis, and the four lines below will be wound diagonally.

7. The line on the nail is the shaft, and the two lines below are winding and oblique.

8. Nail the thread as a shaft, press it on the thread for winding and oblique winding.

9. Nail two lines to make an axis, make a winding under the pressure of the line, and make a diagonal knot at the intersection of the two lines.

10, the thread nailed on the shaft is used as the shaft, and the following three threads are used for winding and oblique winding.

1 1. Nail two straight lines as axes and wind them under the pressure of the straight lines, and the intersection of the two straight lines will also be wound obliquely.

Lines 12 and 1 are the first lines in the belly of the fish, and line 3 is the first line in the back of the fish, plus a black line of 20 cm.

13, fish in the middle (label 2) and line 3.

14. Nail it on the iron wire to make a shaft, and do winding and oblique winding under the pressure of the iron wire. Divide the line 15 into three parts, as shown.

15, weaving the middle tail.

16. Do the same for the other two tails.

17, take a black line, put on two black beads, and make a fish eye, and the little goldfish does this.