Rena accelerator disassembly tutorial

The assembly and disassembly steps of Rena universal joint are as follows: 1. Remove the axle lock nut; 2. Support the car on the crane and lift the car to a proper height; 3. Loosen the six fixing bolts of the inner ball cage; 4. Remove the control arm ball head from the steering knuckle; 5. Dismantle the axle shaft from one side of the outer ball cage to avoid damaging the axle shaft dust cover; 6. Dismantle the half shaft and the ball cage: loosen the clips on both sides of the ball cage dust cover, remove the ball cage dust cover and check whether the dust cover is damaged or aging, and remove the circlip: if the circlip is installed outside the ball cage, use the outer circlip pliers to open the circlip and remove the outer ball cage; If the clamp spring is installed in the ball cage, knock the outer ring of the ball cage with a hammer to separate the ball cage from the half shaft; 7. Dismantle the ball cage: knock the inner ring of the ball cage with a copper hammer to make the ball cage and the inner ring perpendicular to the outer ring, and remove the inner ring, the ball cage and the steel ball; 8. Install in the reverse order of disassembly to complete the replacement.