What is the matching channel number of Volkswagen throttle?

Pacific Auto Network 098: used for Shanghai Volkswagen and FAW-Volkswagen, such as Santana and Jetta King. 060: used for Shanghai Volkswagen and FAW-Volkswagen, such as New Bora and Audi A6L. 00 1: used in old Audi and Jetta avant-garde cars.

Adjust the matched channel number to 060 and the five valves to 098. Matching Volkswagen's throttle with X-43 1 shows that throttle adjustment matching is only applicable to Volkswagen with electronic throttle engine system, and Santana GLi is not in the matching range.

Basic setting: When the ignition switch is turned on, the throttle control unit and the engine control unit can adapt themselves. Basic setting process: the throttle is basically set, and the throttle regulator enters the minimum position from the maximum position during emergency operation.

Extended Information: Precautions for Throttle Cleaning:

1. If there is too much sludge in the accelerator, it may cause poor engine acceleration and increase fuel consumption, which is a big worry for the owner. What should I do if the throttle is dirty? As long as you clean it, you can get it in the 4S shop quickly, but don't you go to the 4S shop every time? Actually, you don't have to. You can handle it yourself. Just don't forget to initialize.

2. Apply a little oil on the fixed metal beam ring first to avoid the teeth slipping during disassembly. Remove the metal wire harness ring of the throttle hose. After the hose is removed, the left end is the position of the throttle. Remove the negative electrode of the battery, turn off the ignition switch, straighten the throttle plate, spray a small amount of "carburetor cleaner" into the throttle, and then carefully scrub it with polyester rag or high-spin "non-woven fabric". Deep in the throttle, you can hold the rag and scrub it carefully where your hands can't reach it.

3. When cleaning the throttle valve, it is not necessary to disassemble it, but the sealing part of the inlet steam must be cleaned, and the idle motor must be disassembled for cleaning. There are advantages and disadvantages of cleaning nozzles by borrowing and disassembling. Generally speaking, maintenance stations are recommended to disassemble and wash, which can prevent other unnecessary waste, such as replacing the sealing ring or installing other gaskets after disassembly, or delaying the owner's time due to oil leakage during disassembly.

4. After cleaning, initialize the throttle according to the disassembly procedure just now. After cleaning the throttle, it needs to be initialized, because the computer has a memory function when adjusting the throttle opening, because there was sludge blockage in the past. In order to ensure the air intake, the computer will automatically adjust the throttle opening to keep the air intake in a normal state.

5. There is no sludge blockage after cleaning. If the throttle valve still maintains its previous opening, the intake air volume will be too large. As a result, the engine will shake when starting, the acceleration will be weak, and the engine fault light may light up.