LaVida throttle sensor assembly

The cleaning steps and matching methods of LaVida throttle are as follows: 1. Open the engine compartment, disconnect the negative electrode of the battery, remove the engine intake pipe, and empty the throttle position; 2. Unscrew the fixing screws around the throttle assembly and unplug the throttle plug wire harness; 3. Remove the throttle assembly, put on gloves and spray the throttle cleaner; 4. After cleaning, reinstall it according to the steps just removed, and then match the throttle. After cleaning the throttle, it needs to be initialized, because the computer has memory function when adjusting the throttle opening. In addition to using a special decoder to match the throttle, we can also use manual operation. There are two methods for manual operation. The first one is to turn on the key "ACC" switch, then wait for 20 seconds, press the accelerator to the bottom and hold it for about 10 second, then release the accelerator, turn off the ignition switch, and pull out the key to complete the initialization. The second method is to turn on the key "ACC" switch, hold it for 30 seconds, then turn off the ignition switch and pull out the key. If the above two methods are not applicable, go directly to the 4S shop to complete the matching work.