How to make an alcohol stove

Tools: scissors, knives, pliers

Steps/methods

& gt0 1 Cut a jar, first measure the height to be cut as the lower part of the furnace body.

& gt02 Start cutting. In fact, cans are very thin and easy to cut.

& gt03 After cutting

& gt In the same way, cut the other one, but the height is shorter than the first one, and use it as the upper part of the furnace body.

& gt05 ok, and then cut off the other end of the remaining material for use as the inside of the furnace body.

& gt Now start to make the inside of the furnace body, and cut off the remaining materials just now.

& gt After cutting, roll it up and put it in the lower part of the furnace body, and measure the height and diameter.

& gt08 Mark the height and diameter, and start flanging and connection.

& gt09 The hem is spliced and the high part is cut off.

& gt 10 ok, now help the upper part of the furnace to be treated, and poke a small hole first.

& gt 1 1 poke a small hole and open your mouth. Because the bottom is thick, it is difficult to open, and the tools are simple, so it is made like this.

& gt 12 Next, vertically cut the edge of the upper material of the furnace body. What is this for? Because the upper and lower materials have the same diameter, it is difficult to put the upper cover in without cutting.

& gt 13 just cut the cover. This is the way it can't be opened.

& gt 14 is finished, and it's about to be tested.

& gt 15 is ignited by adding alcohol.

>16 burns for about 20 seconds.

& gt 17 started to boil water, and I used the lunch box in the imitation American kettle. The capacity is about 700ML. Shelves are used to cook and steam things, hehe.

& gt 18 is burning red.

& gt 19 prepare for boiling, about 10 minutes.