How to install the plastic buckle plate ceiling

Now people look at the decoration is very important, because a good decoration not only can let themselves have a good mood will also let themselves have a good living environment, the previous people do not understand what is the ceiling, but with the development of the times, the ceiling of a lot of kinds, such as today to say is the buckle plate ceiling, may be some families is the buckle plate ceiling, but some are not, and some people would like to know how to install the buckle plate ceiling, today I give you an introduction, we can listen carefully, it is very practical ah. Today I introduce to you, you can listen carefully, very practical ah.

Button board ceiling installation method

1, the installation of plastic button board ceiling, the first step first to determine the location of the ceiling installation, that is, the ceiling height. Usually the ceiling should not be too low, the height is too low will make the space look depressing. Determine the installation height, with an ink line in the surrounding wall line elevation, baseline labeling should be clear;

2, according to the ceiling design, ceiling area to determine the size of the plastic buckle plate specifications;

3, determine the location of the keel line. Because the keel is mainly used to support the outside decorative materials modeling, fixed structure, in the case of plastic buckle plate size has been determined, in order to ensure the integrity of the installation, according to the panel specifications to determine the structural dimensions of the keel and the location of the line, and will determine the location of the line is marked on the upper edge of the reference line;

4, the main keel installation. Main keel hanging point spacing, according to the design of the recommended series selection, the middle part should be arched, keel arch height is not less than 1/200 of the span of the room surface. main keel installation in a timely manner after the correction of the position and height. Pull out the longitudinal and transverse elevation control line, starting from one end, while installing and adjusting the suspension height of the boom, in order to control the leveling of the keel frame. To be a large surface leveling, and then some of the single keel with bending and warping adjustments, until the leveling meets the requirements. In the installation of the main keel, but also pay attention to stay out of the exit of the lighting line;

5, the installation of the boom. Boom installation should meet several requirements: first of all, the boom should be straight and have sufficient bearing capacity; secondly, the boom should be rust-proof treatment; boom from the end of the main keel shall not exceed 300mm, otherwise additional boom should be installed, if you need to increase the boom, it is best to lap weld to avoid the main keel falling;

6, side keel installation. Side keel should be installed close to the main keel. After installing the main and side keel, check the keel flatness and firmness;

7, plastic buckle plate installation. Plastic buckle plate according to the strip once parallel buckle in the keel, with special connectors connected. It should be noted that, in the installation of the last board should be in accordance with the actual size according to the last, cut with a cutter, the panel will be slightly bent into, and finally on both sides of the sealing with pressure strip.

The above is a small introduction to the buckle plate ceiling installation method, as can be seen from the above, buckle plate ceiling installation is somewhat complex, total **** there are seven steps, but we follow the introduction to install, that side is not difficult, as long as a little bit of seriousness can be, in addition, if you do not have too much knowledge of this aspect of the ceiling, you will learn more about it, learn more about it to know what to choose! What kind of, well, small introduction here, I hope to help you.