Manufacturing method of tenon-mortise table

How to make a mortise and tenon table is shared as follows:

First, make 1 1 long board and 30 short board according to the design size, and mill the slot with bakelite. Then make four table bearing materials and combine them into a table bearing frame. Then, the four table legs are clamped on the table support frame in turn, and finally, a checkered table top with staggered length is installed on it. Here are the specific steps.

The table consists of four table supports and four table legs, and the joint is composed of creative three-pronged tenon. The table frame size is 450mm* 1020mm, and the wood size is 30mm square. The table top adopts 1 1 horizontal plate and 30 vertical plate, the plate size is 30* 10mm, and the intersection points are meshed with each other by clips and tenons.

The whole desktop is a lattice desktop made up of 1 1 horizontal boards and 30 vertical boards. Firstly, the tabletop is milled with bakelite on a board with a thickness of 30mm, a width of 450mm and a length of not less than 300mm, and 1/kloc-0 *15 mm/groove is milled according to the design size.

After completion, 30 boards with a thickness of 10mm were cut with a chainsaw. Similarly, make a 1 1 long transverse plate according to the design size, and then polish off the sawdust and dust on the board with fine sandpaper.

Table support is a frame table support composed of two long (horizontal) and two short (vertical) tables. The tenons and grooves of 15* 15mm on the two long (horizontal) ends are milled by bakelite milling machine, and tenons and grooves of 15* 15mm are also milled inside.

On the outside of the two short (vertical) ends, a tenon of 15* 15mm is milled with bakelite, and then a round tenon is chiseled by hand to make it a tenon with a circular diameter of 15mm. ..

The four legs of the table are also 30*30mm square timber with a length of 450 mm According to the design, a square tenon of 15* 15mm is milled on the upper end of the table leg with bakelite.

Because this table is a pure mortise and tenon structure, the standard requirements for mortise and tenon will be very high when making it. It is best to assist some electric tools, and choose wood with high density and certain hardness.

It's time to show your true skill! Many wooden friends asked me, "What is the structure formed by the intersection of three pieces of wood?" Let's reveal the secret below. In fact, it is very simple, consisting of three groups of tenons, one of which needs to be made into a circle and then assembled.

Specifically: firstly, clamp the short (vertical) tenon end of the table bearing on the long (horizontal) tenon end, and pay attention to the tenon facing outwards (in the opposite direction).

Clip the table leg (square tenon) into the tenon groove, and then rotate the round tenon end counterclockwise by 90. After the square timber returns to its place, the three boards intersect and bite each other, forming the legendary "three-pronged tenon".