Traditional Culture Encyclopedia - Traditional culture - How to put the car handbrake?
How to put the car handbrake?
Function and structure of automobile manual brake
If you want to know how to use the handbrake, you must know the function and structure of the handbrake. The scientific name of the handbrake is parking brake, which mainly controls the rear wheels. To put it bluntly, it is usually used when parking on a flat road or slope. The structure is shown in the figure, and the structure is very simple, mainly consisting of handles and buttons.
Please click to enter a picture description.
Hand brake principle Looking at the picture, we use the lever principle to pull the brake device of the rear wheel through the steel wire, mainly looking at the locking teeth and teeth. These two parts are automatically joined together:
Hand brake (braking the rear wheel): when the handle is pulled up, the tooth will automatically spring up and bite the next tooth, and the steel wire connected below will slowly tighten, thus braking the rear wheel brake pad;
Release the brake (release the rear wheel): Press the handle button and the teeth will separate. At this time, press the handle to loosen the tight steel wire, so that the rear wheel brake is released;
Please click to enter a picture description.
end
How to use the manual car handbrake?
The working principle of the handbrake has been mentioned above. Let's first look at how to pull the handbrake, that is, the handbrake. Look at the picture. Don't worry about the button. Hold the handle with your right hand and pull it up. Don't be too violent When pulling, you will hear a click, which is the sound of teeth and gears locking. You can get 78 points without pulling to the highest level (different cars have different performance)
Please click to enter a picture description.
As shown in the figure, the approximate position behind the handle brake.
Please click to enter a picture description.
Then how to release the brake, look at the picture, hold the handle, press the button with your thumb, press the button! Then press the handle to basically flatten the handle (the state before pulling up).
Please click to enter a picture description.
As shown in the figure, after releasing the handbrake, the handbrake is roughly positioned. * Pay attention to press the button when releasing the handbrake. I was scolded many times when I was just learning (_).
Please click to enter a picture description.
five
Several points for attention:
Release the brake, press the button (keep pressing the button), and press the handle to the bottom at the same time;
Hand brake, to what extent? Parking on the slope can be tightened to prevent slipping back, and parking on the flat road can be pulled to seven or eight points;
Remember, the hand brake can't replace the foot brake, nor can it be pulled up for a long time, because the steel wire will be deformed after a long time, which will affect the braking performance. In fact, this factor should be considered without pulling to the end;
When starting, be sure to hold the hand brake. Sometimes the handbrake won't tighten when leveling the road, but you can start when waiting. If you forget to pull the hand brake, it will wear the rear wheel brake device and even burn out the parts, which is very prone to accidents, so remember this;
- Previous article:A masterpiece of Qingming outing
- Next article:Proportion and method of sour plum wine
- Related articles
- What food to eat in Guangxi on the winter solstice
- My son wants to eat beggar chicken. What should I do with a beggar chicken?
- Types and uses of Shanxi folk paper-cutting
- The overall strategy of the decoration process: the ordering and installation sequence of the main materials for decoration.
- What can I put in the room to make my luck better?
- Advantages and disadvantages of virus marketing
- Good sentences, paragraphs and articles about the new year's new atmosphere
- Ideological and moral cultivation and legal basis case analysis questions, seek answers, tell me what you know, thank you.
- How much is Yunnan bride price?
- What are the advantages and disadvantages of feedforward control systems?