How to clean the fan fastest and cleanest?

The quickest and cleanest way to clean the fan: detergent+baking soda+water+rag, white vinegar+detergent+toilet water+water+sponge.

1, detergent+baking soda+water+rag

You need to prepare a watering can, and prepare what you need first. It's actually quite simple. Just put the detergent and baking soda into the bottle according to the ratio of 1: 1, and then add a proper amount of water and stir well.

And then sprayed on the net cover and blades of the fan. It takes some time to dissolve the dirt on it. After that, we can clean the fan with a clean rag.

In the process of using this method, we must pay attention to the place of the fan motor, and we must not spray it, because it is easy to touch the liquid and it will short circuit and the fan will directly break down. It should be noted that this cleaning method is more suitable for electric fans with high cleaning frequency and not too dirty.

2, white vinegar+detergent+toilet water+water+sponge

First, pour the prepared four liquids into a container and add appropriate amount of water. Stir well and pour into the watering can for more uniformity.

Then aim the watering can at the blades of the electric fan and the cover outside, and spray it carefully. Don't turn on the electricity at this time. After spraying, wait a while. During this time, we will use a knife to pull several knives into small squares, but don't cut them.

In about five minutes, we can put a plastic bag on the fan, and the bag must be tied tightly after winding, otherwise it will be easily blown away when the fan is turned on later.

After that, you can start plugging in and blow with the maximum wind for about five minutes. At this point, the blades of the fan have been cleaned. After cleaning the leaves, we will clean the covering on the outer surface with the newly cut sponge.

Maintenance skills of electric fan

1. The blades of electric fans are important parts. Bearing heaters must be protected during installation, disassembly, scrubbing or use to prevent deformation.

2. The ceiling fan speed control knob should rotate slowly and sequentially, not in the gear position, otherwise the ceiling fan will easily get hot and burn the machine.

3, electric fan with oil or dust, should be removed in time. Do not use gasoline or strong alkali solution to wipe, so as not to damage the function of paint parts on the surface of bearing heater.

4. If the electric fan is hot, abnormally burnt, shaking its head is invalid, and the bearing heater is slow, don't continue to use it. Cut off the power supply in time for maintenance.

5. When starting the electric fan, it is best to use the fast gear first, and then adjust it to the slow gear after the speed is normal. This not only helps to protect the electric fan, but also saves electricity.

6. When using an electric fan in summer, it is forbidden to blow for too long after rapid heating and the wind force is too large. It's best to shake your head, slow down, and naturally keep out the wind, but it's better to sleep in the wind.

7. Desktop and floor electric fans must use three-core plugs and sockets with safety grounding wires; The ceiling fan should be installed at a higher position on the ceiling without grounding wire.