How to realize the wireless bridge between the optical fiber cat e8-c and Tengda wireless router (there is no network cable in the middle)

The steps of wireless bridge between two routers are as follows (take TP router diagram as an example for reference of other routers):

Settings for the first wireless router

1 Log in to the router connected to the broadband cat first, as shown in the figure.

2. Set "SSID number" and "Channel" in Wireless Settings-Basic Settings, and set a fixed channel number, as shown?

3 Set the wireless signal encryption information in Wireless Settings-Wireless Security Settings. Record the setting SSID, channel and encryption setting information of the wireless router.

Settings for the second wireless router

Log in to the second wireless router that needs to be bridged.

In the network parameters-LAN port settings, change the IP address to be different from the first router (to prevent IP address conflict).

For example,192.168.1.2, the router will automatically restart after saving.

Select "Turn on WDS" in "Wireless Settings-Basic Settings". Click "Scan" to search for surrounding wireless signals. ?

Select the SSID number of the first router from the scanned signal list, as shown in the figure below, and click "Connect".

Set the tunnel to be the same as that of the first router. At the same time, set the encryption information to be the same as the first router, and click "Save". As shown in the figure below:

Shut down the DHCP server. In the DHCP server, select Do Not Enable, save and restart the router. ?

At this point, the first wireless router and the second wireless router have successfully established WDS.